Re: [Xen-devel] new barrier type for paravirt (was Re: [PATCH] virtio_ring: use smp_store_mb)

From: Michael S. Tsirkin
Date: Mon Dec 21 2015 - 06:52:56 EST


On Mon, Dec 21, 2015 at 10:47:49AM +0000, David Vrabel wrote:
> On 20/12/15 09:25, Michael S. Tsirkin wrote:
> >
> > I noticed that drivers/xen/xenbus/xenbus_comms.c uses
> > full memory barriers to communicate with the other side.
> > For example:
> >
> > /* Must write data /after/ reading the consumer index. * */
> > mb();
> >
> > memcpy(dst, data, avail);
> > data += avail;
> > len -= avail;
> >
> > /* Other side must not see new producer until data is * there. */
> > wmb();
> > intf->req_prod += avail;
> >
> > /* Implies mb(): other side will see the updated producer. */
> > notify_remote_via_evtchn(xen_store_evtchn);
> >
> > To me, it looks like for guests compiled with CONFIG_SMP, smp_wmb and smp_mb
> > would be sufficient, so mb() and wmb() here are only needed if
> > a non-SMP guest runs on an SMP host.
> >
> > Is my analysis correct?
>
> For x86, yes.
>
> For arm/arm64 I think so, but would prefer one of the Xen arm
> maintainers to confirm. In particular, whether inner-shareable barriers
> are sufficient for memory shared with the hypervisor.
>
> > So what I'm suggesting is something like the below patch,
> > except instead of using virtio directly, a new set of barriers
> > that behaves identically for SMP and non-SMP guests will be introduced.
> >
> > And of course the weak barriers flag is not needed for Xen -
> > that's a virtio only thing.
> >
> > For example:
> >
> > smp_pv_wmb()
> > smp_pv_rmb()
> > smp_pv_mb()
>
> The smp_ prefix doesn't make a lot of sense to me here since these
> barriers are going to be the same whether the kernel is SMP or not.
>
> David

Guest kernel - yes. But it's only needed because you
are running on an SMP host.

--
MST
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/