Re: [PATCH 0/2] DRA72/DRA74: Add 2 lane support

[Kishon Vijay Abraham I]

Hi Tony,

On Thursday 07 January 2016 11:43 PM, Tony Lindgren wrote:
> * Bjorn Helgaas <helgaas@xxxxxxxxxx> [160107 09:42]:
>> [+cc Richard]
>>
>> Hi Kishon,
>>
>> On Wed, Jan 06, 2016 at 04:19:51PM +0530, Kishon Vijay Abraham I wrote:
>>> Add driver modifications in pci-dra7xx to get x2 mode working in
>>> DRA72 and DRA74. Certain modifications is needed in PHY driver also
>>> which will be sent as a separate series.
>>>
>>> Certain board modifications has to be done in order to test
>>> x2 mode in dra72-evm.
>>>
>>> These patches were created on pci next.
>>>
>>> Changes from RFC:
>>> *) .b1co_mode_sel_mask is now set with the correct value.
>>> *) cleanup the patch
>>>
>>> Kishon Vijay Abraham I (2):
>>>   pci: host: pci-dra7xx: use "num-lanes" property to find phy count
>>>   pci: host: pci-dra7xx: Enable x2 mode support
>>>
>>>  Documentation/devicetree/bindings/pci/ti-pci.txt |    8 +-
>>>  drivers/pci/host/pci-dra7xx.c                    |  104 +++++++++++++++++++---
>>>  2 files changed, 97 insertions(+), 15 deletions(-)
>>
>> Apparently dra7xx in mainline doesn't work [1].  Until that's
>> resolved, I'm going to ignore dra7xx patches.
> 
> Agreed. Guys, please do the development _and_ testing on the mainline
> kernel. We do have the mainline kernel usable for probably a few
> tens of omap SoC variants. If you have issues using dra7 with mainline,
> please fix those issues ASAP.

Here Bjorn meant pci-dra7xx is broken in mainline and not the dra7xx boot
as such. (which is due to the absence of reset controller driver).
All the patches to pci-dra7xx were tested on mainline kernel (having
out-of-tree reset patches since the reset controller driver is not merged).
> 
> Ideally of course please also use the device you're working on to
> send out the patches :)

dra7x is the only device that use this pci driver and all the patches to
pci-dra7xx have been tested on both dra7 and dra72 boards.

Thanks
Kishon