Re: [PATCH] mmc: dw_mmc: fix num_slots setting

[Jaehoon Chung]

Hi, Shawn.

On 01/22/2016 04:43 PM, Shawn Lin wrote:
> This patch make num_slots to 1 if pdata->num_slot is not
> defined. Meanwhile, we need to make sure num_slots should
> not larger that the supported slots
> 
> Signed-off-by: Shawn Lin <shawn.lin@xxxxxxxxxxxxxx>
> ---
> 
>  drivers/mmc/host/dw_mmc.c | 16 +++++++++-------
>  1 file changed, 9 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
> index 7128351..065a8f5 100644
> --- a/drivers/mmc/host/dw_mmc.c
> +++ b/drivers/mmc/host/dw_mmc.c
> @@ -2949,12 +2949,6 @@ int dw_mci_probe(struct dw_mci *host)
>  		}
>  	}
>  
> -	if (host->pdata->num_slots < 1) {
> -		dev_err(host->dev,
> -			"Platform data must supply num_slots.\n");
> -		return -ENODEV;
> -	}
> -
>  	host->biu_clk = devm_clk_get(host->dev, "biu");
>  	if (IS_ERR(host->biu_clk)) {
>  		dev_dbg(host->dev, "biu clock not available\n");
> @@ -3111,7 +3105,15 @@ int dw_mci_probe(struct dw_mci *host)
>  	if (host->pdata->num_slots)
>  		host->num_slots = host->pdata->num_slots;
>  	else
> -		host->num_slots = SDMMC_GET_SLOT_NUM(mci_readl(host, HCON));
> +		host->num_slots = 1;

If host->nums_slots is set to 1, it assumes that there is one slot.
Then the code in dw_mci_parse_dt() can be removed 

                dev_info(dev,
                         "num-slots property not found, assuming 1 slot is available\n");
                pdata->num_slots = 1;


Best Regards,
Jaehoon Chung
            

> +
> +	if (host->num_slots < 1 ||
> +	    host->num_slots > SDMMC_GET_SLOT_NUM(mci_readl(host, HCON))) {
> +		dev_err(host->dev,
> +			"Platform data must supply correct num_slots.\n");
> +		ret = -ENODEV;
> +		goto err_clk_ciu;
> +	}
>  
>  	/*
>  	 * Enable interrupts for command done, data over, data empty,
>