Re: [PATCH v3 5/5] pinctrl: sunxi: Use pin number when calling sunxi_pmx_set

[Chen-Yu Tsai]

On Thu, Feb 4, 2016 at 7:33 AM, Krzysztof Adamski <k@xxxxxxxx> wrote:
> sunxi_pmx_set accepts pin number and then calculates offset by
> subtracting pin_base from it. sunxi_pinctrl_gpio_get, on the other hand,
> gets offset so we have to convert it to pin number so we won't get
> negative value in sunxi_pmx_set.
>
> This was only used on A10 so far, where there is only one GPIO chip with
> pin_base set to 0 so it didn't matter. However H3 also requires this
> workaround but have two pinmux sections, triggering problem for PL port.
>
> Signed-off-by: Krzysztof Adamski <k@xxxxxxxx>

Acked-by: Chen-Yu Tsai <wens@xxxxxxxx>

(resent as my mail setup failed to deliver)