Re: [PATCH v2 2/4] Documentation: Bindings: Add STM32 DWMAC glue

[Joachim Eastwood]

Hi Alexandre,

You should copy 'devicetree@xxxxxxxxxxxxxxx' on bindings doc. Adding cc here.

On 23 February 2016 at 16:10, Alexandre TORGUE
<alexandre.torgue@xxxxxxxxx> wrote:
> Signed-off-by: Alexandre TORGUE <alexandre.torgue@xxxxxxxxx>
>
> diff --git a/Documentation/devicetree/bindings/net/stm32-dwmac.txt b/Documentation/devicetree/bindings/net/stm32-dwmac.txt
> new file mode 100644
> index 0000000..18734b3
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/stm32-dwmac.txt
> @@ -0,0 +1,41 @@
> +STMicroelectronics STM32 / MCU DWMAC glue layer controller
> +
> +This file documents platform glue layer for stmmac.
> +Please see stmmac.txt for the other unchanged properties.
> +
> +The device node has following properties.
> +
> +Required properties:
> +- compatible:  Should be "st,stm32-dwmac" to select glue, and
> +              "snps,dwmac-3.50a" to select IP vesrion.
> +- clocks: Should contain the GMAC main clock, and tx clock
> +- compatible:  Should be "st,stm32-dwmac" to select glue and
> +              "snps,dwmac-3.50a" to select IP version.
> +- clocks: Should contain the MAC main clock
> +- clock-names: Should contain the clock names "stmmaceth".
> +- st,syscon : Should be phandle/offset pair. The phandle to the syscon node which
> +             encompases the glue register, and the offset of the control register.
> +
> +Optional properties:
> +- clocks: Could contain:
> +       - the tx clock,
> +       - the rx clock
> +- clock-names: Could contain the clock names "tx-clk", "rx-clk"
> +
> +Example:
> +
> +               ethernet0: dwmac@40028000 {
> +                       device_type = "network";

What is this 'device_type = "network"' for?
It seems to used in a lot of powerpc DTs, but only a couple of arm DTs.

Maybe Rob could enlighten us?

> +                       compatible = "st,stm32-dwmac", "snps,dwmac-3.50a";
> +                       status = "disabled";
> +                       reg = <0x40028000 0x8000>;
> +                       reg-names = "stmmaceth";
> +                       interrupts = <0 61 0>, <0 62 0>;
> +                       interrupt-names = "macirq", "eth_wake_irq";
> +                       clock-names = "stmmaceth", "tx-clk", "rx-clk";
> +                       clocks = <&rcc 0 25>, <&rcc 0 26>, <&rcc 0 27>;
> +                       st,syscon = <&syscfg 0x4>;
> +                       snps,pbl = <32>;

Regarding snps,pbl; using 32 here might not give you what you would except.
See comment in dwmac1000_dma_init().

The driver is hard coded to use PBL4X/PBL8X mode. Just a heads up.


regards,
Joachim Eastwood