[PATCH v2 1/2] Irq/mbigen:Change the mbigen node definition in dt binding file

[MaJun]

From: Ma Jun <majun258@xxxxxxxxxx>

For mbigen module, there is a special case that more than one mbigen
device nodes use the same reg definition in DTS when these devices
exist in the same mbigen hardware module.

To fix the mbigen IO remap problem, the mbigen node definition and
structure are changed based on Mark Rutland's suggestion.

Signed-off-by: Ma Jun <majun258@xxxxxxxxxx>
---
 .../interrupt-controller/hisilicon,mbigen-v2.txt   |   22 +++++++++++++++----
 1 files changed, 17 insertions(+), 5 deletions(-)

diff --git a/Documentation/devicetree/bindings/interrupt-controller/hisilicon,mbigen-v2.txt b/Documentation/devicetree/bindings/interrupt-controller/hisilicon,mbigen-v2.txt
index 720f7c9..3b2f4c4 100644
--- a/Documentation/devicetree/bindings/interrupt-controller/hisilicon,mbigen-v2.txt
+++ b/Documentation/devicetree/bindings/interrupt-controller/hisilicon,mbigen-v2.txt
@@ -21,6 +21,8 @@ Mbigen main node required properties:
 - reg: Specifies the base physical address and size of the Mbigen
   registers.
 
+Mbigen sub node required properties:
+------------------------------------------
 - interrupt controller: Identifies the node as an interrupt controller
 
 - msi-parent: Specifies the MSI controller this mbigen use.
@@ -45,13 +47,23 @@ Mbigen main node required properties:
 
 Examples:
 
-	mbigen_device_gmac:intc {
+	mbigen_chip_dsa {
 			compatible = "hisilicon,mbigen-v2";
 			reg = <0x0 0xc0080000 0x0 0x10000>;
-			interrupt-controller;
-			msi-parent = <&its_dsa 0x40b1c>;
-			num-pins = <9>;
-			#interrupt-cells = <2>;
+
+			mbigen_gmac:intc_gmac {
+				interrupt-controller;
+				msi-parent = <&its_dsa 0x40b1c>;
+				num-pins = <9>;
+				#interrupt-cells = <2>;
+			};
+
+			mbigen_i2c:intc_i2c {
+				interrupt-controller;
+				msi-parent = <&its_dsa 0x40b0e>;
+				num-pins = <2>;
+				#interrupt-cells = <2>;
+			};
 	};
 
 Devices connect to mbigen required properties:
-- 
1.7.1