Re: [PATCH] regulator: twl: Enable regulators over the powerbus as well

[Ivaylo Dimitrov]

On 25.03.2016 17:54, Mark Brown wrote:
> On Fri, Mar 25, 2016 at 04:02:59PM +0100, Sebastian Reichel wrote:
> > On Fri, Mar 25, 2016 at 11:17:57AM +0000, Mark Brown wrote:
> > > On Wed, Mar 23, 2016 at 09:22:36PM +0200, Ivaylo Dimitrov wrote:
>
> > > > Assigning a device group to a regulator does not change its state. To
> > > > change the state of a regulator a message over the powerbus is required.
> > > > Also, the check for the current state of a regulator should not count on
> > > > a device group being assigned, but on the current resource state.
>
> > > How did this driver ever work then?  It sounds like there must be
> > > something else going on here.

In short - it does not work, the voltages and regulator states are left 
on the mercy of the reset defaults and the bootloader.

> >  From my understanding of the twl4030 TRM assigning a device group
> > means "<device group> wants this regulator enabled". It does not
> > change the regulator mode (sleep vs normal or in regulator-framework
> > terms: REGULATOR_STATUS_NORMAL vs REGULATOR_STATUS_STANDBY).
>
> > It usually works, since the default state is normal. If the system
> > is rebooted from a non-mainline kernel, which left the regulator in
> > sleep/standby, nothing in the kernel switches it to normal.

This is exactly what happens

> I really can't tell how anyone could get from the changelog to what
> you're saying about modes.  The explanation needs to be *much* clearer.
>
> Part of the confusion is that if you're trying to do something to do
> with the mode support that really needs to use the mode APIs, enabling
> or disabling the regulator should not silently change the mode.

Ok, so you say that regulator framework should call 
twl4030reg_set_mode(), but it doesn't. If that is the case, then the bug 
is in the regulator framework, a similar one to what you've fixed in 
"regulator: core: Always flag voltage constraints as appliable".