[PATCH 02/12] mtd: nand: atmel: rely on generic DT parsing done in nand_scan_ident()

[Boris Brezillon]

The core now takes care of parsing generic DT properties in
nand_scan_ident() when nand_set_flash_node() has been called.
Rely on this initialization instead of calling of_get_nand_xxx()
manually.

Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxxxxxxx>
---
 drivers/mtd/nand/atmel_nand.c | 133 +++++++++++++++++++++++-------------------
 1 file changed, 73 insertions(+), 60 deletions(-)

diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 0b5da72..5e716f2 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -36,7 +36,6 @@
 #include <linux/of.h>
 #include <linux/of_device.h>
 #include <linux/of_gpio.h>
-#include <linux/of_mtd.h>
 #include <linux/mtd/mtd.h>
 #include <linux/mtd/nand.h>
 #include <linux/mtd/partitions.h>
@@ -434,14 +433,13 @@ err_buf:
 static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len)
 {
 	struct nand_chip *chip = mtd_to_nand(mtd);
-	struct atmel_nand_host *host = nand_get_controller_data(chip);
 
 	if (use_dma && len > mtd->oobsize)
 		/* only use DMA for bigger than oob size: better performances */
 		if (atmel_nand_dma_op(mtd, buf, len, 1) == 0)
 			return;
 
-	if (host->board.bus_width_16)
+	if (chip->options & NAND_BUSWIDTH_16)
 		atmel_read_buf16(mtd, buf, len);
 	else
 		atmel_read_buf8(mtd, buf, len);
@@ -450,14 +448,13 @@ static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len)
 static void atmel_write_buf(struct mtd_info *mtd, const u8 *buf, int len)
 {
 	struct nand_chip *chip = mtd_to_nand(mtd);
-	struct atmel_nand_host *host = nand_get_controller_data(chip);
 
 	if (use_dma && len > mtd->oobsize)
 		/* only use DMA for bigger than oob size: better performances */
 		if (atmel_nand_dma_op(mtd, (void *)buf, len, 0) == 0)
 			return;
 
-	if (host->board.bus_width_16)
+	if (chip->options & NAND_BUSWIDTH_16)
 		atmel_write_buf16(mtd, buf, len);
 	else
 		atmel_write_buf8(mtd, buf, len);
@@ -1507,58 +1504,17 @@ static void atmel_nand_hwctl(struct mtd_info *mtd, int mode)
 		ecc_writel(host->ecc, CR, ATMEL_ECC_RST);
 }
 
-static int atmel_of_init_port(struct atmel_nand_host *host,
-			      struct device_node *np)
+static int atmel_of_init_ecc(struct atmel_nand_host *host,
+			     struct device_node *np)
 {
-	u32 val;
 	u32 offset[2];
-	int ecc_mode;
-	struct atmel_nand_data *board = &host->board;
-	enum of_gpio_flags flags = 0;
-
-	host->caps = (struct atmel_nand_caps *)
-		of_device_get_match_data(host->dev);
-
-	if (of_property_read_u32(np, "atmel,nand-addr-offset", &val) == 0) {
-		if (val >= 32) {
-			dev_err(host->dev, "invalid addr-offset %u\n", val);
-			return -EINVAL;
-		}
-		board->ale = val;
-	}
-
-	if (of_property_read_u32(np, "atmel,nand-cmd-offset", &val) == 0) {
-		if (val >= 32) {
-			dev_err(host->dev, "invalid cmd-offset %u\n", val);
-			return -EINVAL;
-		}
-		board->cle = val;
-	}
-
-	ecc_mode = of_get_nand_ecc_mode(np);
-
-	board->ecc_mode = ecc_mode < 0 ? NAND_ECC_SOFT : ecc_mode;
-
-	board->on_flash_bbt = of_get_nand_on_flash_bbt(np);
-
-	board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma");
-
-	if (of_get_nand_bus_width(np) == 16)
-		board->bus_width_16 = 1;
-
-	board->rdy_pin = of_get_gpio_flags(np, 0, &flags);
-	board->rdy_pin_active_low = (flags == OF_GPIO_ACTIVE_LOW);
-
-	board->enable_pin = of_get_gpio(np, 1);
-	board->det_pin = of_get_gpio(np, 2);
+	u32 val;
 
 	host->has_pmecc = of_property_read_bool(np, "atmel,has-pmecc");
 
-	/* load the nfc driver if there is */
-	of_platform_populate(np, NULL, NULL, host->dev);
-
-	if (!(board->ecc_mode == NAND_ECC_HW) || !host->has_pmecc)
-		return 0;	/* Not using PMECC */
+	/* Not using PMECC */
+	if (!(host->nand_chip.ecc.mode == NAND_ECC_HW) || !host->has_pmecc)
+		return 0;
 
 	/* use PMECC, get correction capability, sector size and lookup
 	 * table offset.
@@ -1599,16 +1555,64 @@ static int atmel_of_init_port(struct atmel_nand_host *host,
 		/* Will build a lookup table and initialize the offset later */
 		return 0;
 	}
+
 	if (!offset[0] && !offset[1]) {
 		dev_err(host->dev, "Invalid PMECC lookup table offset\n");
 		return -EINVAL;
 	}
+
 	host->pmecc_lookup_table_offset_512 = offset[0];
 	host->pmecc_lookup_table_offset_1024 = offset[1];
 
 	return 0;
 }
 
+static int atmel_of_init_port(struct atmel_nand_host *host,
+			      struct device_node *np)
+{
+	u32 val;
+	struct atmel_nand_data *board = &host->board;
+	enum of_gpio_flags flags = 0;
+
+	host->caps = (struct atmel_nand_caps *)
+		of_device_get_match_data(host->dev);
+
+	if (of_property_read_u32(np, "atmel,nand-addr-offset", &val) == 0) {
+		if (val >= 32) {
+			dev_err(host->dev, "invalid addr-offset %u\n", val);
+			return -EINVAL;
+		}
+		board->ale = val;
+	}
+
+	if (of_property_read_u32(np, "atmel,nand-cmd-offset", &val) == 0) {
+		if (val >= 32) {
+			dev_err(host->dev, "invalid cmd-offset %u\n", val);
+			return -EINVAL;
+		}
+		board->cle = val;
+	}
+
+	board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma");
+
+	board->rdy_pin = of_get_gpio_flags(np, 0, &flags);
+	board->rdy_pin_active_low = (flags == OF_GPIO_ACTIVE_LOW);
+
+	board->enable_pin = of_get_gpio(np, 1);
+	board->det_pin = of_get_gpio(np, 2);
+
+	/* load the nfc driver if there is */
+	of_platform_populate(np, NULL, NULL, host->dev);
+
+	/*
+	 * Initialize ECC mode to NAND_ECC_SOFT so that we have a correct value
+	 * even if the nand-ecc-mode property is not defined.
+	 */
+	host->nand_chip.ecc.mode = NAND_ECC_SOFT;
+
+	return 0;
+}
+
 static int atmel_hw_nand_init_params(struct platform_device *pdev,
 					 struct atmel_nand_host *host)
 {
@@ -2150,6 +2154,11 @@ static int atmel_nand_probe(struct platform_device *pdev)
 	} else {
 		memcpy(&host->board, dev_get_platdata(&pdev->dev),
 		       sizeof(struct atmel_nand_data));
+		nand_chip->ecc.mode = host->board.ecc_mode;
+
+		/* 16-bit bus width */
+		if (host->board.bus_width_16)
+			nand_chip->options |= NAND_BUSWIDTH_16;
 	}
 
 	 /* link the private data structures */
@@ -2191,11 +2200,8 @@ static int atmel_nand_probe(struct platform_device *pdev)
 		nand_chip->cmd_ctrl = atmel_nand_cmd_ctrl;
 	}
 
-	nand_chip->ecc.mode = host->board.ecc_mode;
 	nand_chip->chip_delay = 40;		/* 40us command delay time */
 
-	if (host->board.bus_width_16)	/* 16-bit bus width */
-		nand_chip->options |= NAND_BUSWIDTH_16;
 
 	nand_chip->read_buf = atmel_read_buf;
 	nand_chip->write_buf = atmel_write_buf;
@@ -2228,11 +2234,6 @@ static int atmel_nand_probe(struct platform_device *pdev)
 		}
 	}
 
-	if (host->board.on_flash_bbt || on_flash_bbt) {
-		dev_info(&pdev->dev, "Use On Flash BBT\n");
-		nand_chip->bbt_options |= NAND_BBT_USE_FLASH;
-	}
-
 	if (!host->board.has_dma)
 		use_dma = 0;
 
@@ -2259,6 +2260,18 @@ static int atmel_nand_probe(struct platform_device *pdev)
 		goto err_scan_ident;
 	}
 
+	if (host->board.on_flash_bbt || on_flash_bbt)
+		nand_chip->bbt_options |= NAND_BBT_USE_FLASH;
+
+	if (nand_chip->bbt_options & NAND_BBT_USE_FLASH)
+		dev_info(&pdev->dev, "Use On Flash BBT\n");
+
+	if (IS_ENABLED(CONFIG_OF) && pdev->dev.of_node) {
+		res = atmel_of_init_ecc(host, pdev->dev.of_node);
+		if (res)
+			goto err_hw_ecc;
+	}
+
 	if (nand_chip->ecc.mode == NAND_ECC_HW) {
 		if (host->has_pmecc)
 			res = atmel_pmecc_nand_init_params(pdev, host);
-- 
2.5.0