Re: [RFC 0/6] mmc: Field Firmware Update

[Gwendal Grignou]

On Thu, Jan 14, 2016 at 5:16 AM, Ulf Hansson <ulf.hansson@xxxxxxxxxx> wrote:
> On 28 December 2015 at 15:12, Alex Lemberg <Alex.Lemberg@xxxxxxxxxxx> wrote:
>> Hi Ulf,
>>
>> We succeeded to run FFU via new mmc multi-command ioctl without any code modification,
>> but only by using Single Sector commands (CMD24).
>>
>> From running the FFU and from code review, we see two minor issues in this way of running FFU:
>> 1. There is no support for Multiple Block write commands (CMD25) in existing IOCTL implementation -
>
> That's right. But I guess we cope without the multiple block support!?
>
> Although, I wonder how hard it would be to add it...
>
>> seems like there is no polling for the card status on data transfer completion.
>
> We should fix that!
>
> In the rpmb case, we check the status so we can probably trigger that
> code to run for CMD24/25 as well.
>
>> (The kernel FFU implementation supports FFU using Multiple Block Write commands).
>> 2. As you probably remember, there are two ways to install the new FW in the end of FFU process -
>> In case MODE_OPERATION_CODES field is not supported by the device, the host sets to NORMAL state
>
> Before starting the update, you can find out which mode that is
> supported and take relevant actions, right?
>
>> and initiates a CMD0/HW_Reset/Power cycle to install the new firmware.
>
> Yes, but that's fragile - as discussed earlier.
>
> What we really need to do is to also remove the "card" device from the
> system, as otherwise we may have invalid data in its member variables
> and who knows what issues that can cause to upper levels.
>
>> This sequence cannot be done via multi-command ioctl, and requires manual reset of the device/platform.
>
> Yepp, it seems so at least for now. Perhaps we can think of a way to
> improve this?
>
>> (The kernel FFU implementation supports both FW install methods).
>>
>> For running FFU via new mmc multi-command ioctl, we have modified mmc-utils and add new functionality for FFU.
>> Please let us know if you want us to submit the patch for mmc-utils FFU functionality via multi-command ioctl.
>
> Yes please. Don't forget to send this to Chris as well!
I am arriving after the battle, but I have finally rebased the eMMC
FFU kernel ffu code to 4.x. It is based on what Avi and Alex have
written.
As stated earlier, the advantage over using MMC_MUTLI_CMD is we can
force a reset and rescan of the card without asking the user to reboot
their machine.
Also, by only sending a firmware name over the ioctl, we can use Kees'
work for firmware validation (https://lwn.net/Articles/605432/).
To prevent downloading firmware from unknown source, we would reject
some commands (like SWITCH with FFU_MODE) in the kernel
MMC_IOC/MULTI_CMD ioctl handler.

Gwendal.
>
> [...]
>
> Kind regards
> Uffe
> --
> To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at  http://vger.kernel.org/majordomo-info.html