[PATCH V3] net: mediatek: update the IRQ part of the binding document
From: John Crispin
Date: Tue Apr 12 2016 - 02:35:33 EST
The current binding document only describes a single interrupt. Update the
document by adding the 2 other interrupts.
The driver currently only uses a single interrupt. The HW is however able
to using IRQ grouping to split TX and RX onto separate GIC irqs.
Signed-off-by: John Crispin <blogic@xxxxxxxxxxx>
Cc: devicetree@xxxxxxxxxxxxxxx
---
This binding doc was merged in 4.6-rc1 and there are no users yet. The
current driver only uses 1 irq but will work fine with all 3 listed in
the devicetree. This patch should be merged before v4.6 is final such
that listing all 3 irqs becomes part of the ABI. I have already posted
a patch that utilizes all 3 irqs for next-next for v4.7 inclusion.
Changes in V3:
* be verbose about the 3 irqs and their ordering
Changes in V2:
* split this patch out of the series that fixes tx stalls in the driver
Documentation/devicetree/bindings/net/mediatek-net.txt | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/net/mediatek-net.txt b/Documentation/devicetree/bindings/net/mediatek-net.txt
index 5ca7929..32eaaca 100644
--- a/Documentation/devicetree/bindings/net/mediatek-net.txt
+++ b/Documentation/devicetree/bindings/net/mediatek-net.txt
@@ -9,7 +9,8 @@ have dual GMAC each represented by a child node..
Required properties:
- compatible: Should be "mediatek,mt7623-eth"
- reg: Address and length of the register set for the device
-- interrupts: Should contain the frame engines interrupt
+- interrupts: Should contain the three frame engines interrupts in numeric
+ order. These are fe_int0, fe_int1 and fe_int2.
- clocks: the clock used by the core
- clock-names: the names of the clock listed in the clocks property. These are
"ethif", "esw", "gp2", "gp1"
@@ -42,7 +43,9 @@ eth: ethernet@1b100000 {
<ðsys CLK_ETHSYS_GP2>,
<ðsys CLK_ETHSYS_GP1>;
clock-names = "ethif", "esw", "gp2", "gp1";
- interrupts = <GIC_SPI 200 IRQ_TYPE_LEVEL_LOW>;
+ interrupts = <GIC_SPI 200 IRQ_TYPE_LEVEL_LOW
+ GIC_SPI 199 IRQ_TYPE_LEVEL_LOW
+ GIC_SPI 198 IRQ_TYPE_LEVEL_LOW>;
power-domains = <&scpsys MT2701_POWER_DOMAIN_ETH>;
resets = <ðsys MT2701_ETHSYS_ETH_RST>;
reset-names = "eth";
--
1.7.10.4