Re: [PATCH 4/4] pinctrl: iproc: Allow PINCONF to be disabled completely

[Ray Jui]

Hi Linus,

On 4/15/2016 1:24 AM, Linus Walleij wrote:
> On Wed, Apr 13, 2016 at 2:15 AM, Ray Jui <ray.jui@xxxxxxxxxxxx> wrote:
>
> > In some of the future iProc based SoCs, pinconf is handled by another
> > block and the iProc GPIO controller is solely used as a GPIO controller.
> > This patch adds support of a new compatible string "brcm,iproc-gpio-only",
> > that is introduced to handle this case, where pinconf functions in this
> > driver are completely disabled
> >
> > Signed-off-by: Ray Jui <ray.jui@xxxxxxxxxxxx>
> > Reviewed-by: Yendapally Reddy Dhananjaya Reddy <yendapally.reddy@xxxxxxxxxxxx>
> > Reviewed-by: Jon Mason <jon.mason@xxxxxxxxxxxx>
> > Reviewed-by: Scott Branden <scott.branden@xxxxxxxxxxxx>
>
> If this was entirely true, then the driver should end up only executing
> [devm_]gpiochip_add_data() but that does not seem to be the case.

Yes, in the case of compatible string "brcm,iproc-gpio-only" is 
detected, the driver only registers 'gpiochip_add_data'. Please check 
patch 2/4 of this series, which takes care of it.

> You are still registering a pin controller, right? Just disabling some of
> the pin config options. The pin multiplexing is still there, right?
> Then it is not "solely a GPIO controller". Not at all.

This driver does not register itself as a PINCONF driver if 
"brcm,iproc-gpio-only" compatible string is detected. This is addressed 
in patch 2/4 of this series.

Pin based IOMUX GPIO override is only activated when 
'chip->pinmux_is_supported' is true, and it is only true if the optional 
DT property "gpio-ranges" is defined.

> This patch set needs some elaboration I think.
>
> Yours,
> Linus Walleij

I believe the current issue with this patch series is now only on the 
naming of the new compatible string "brcm,iproc-gpio-only". Please 
correct me if I'm wrong.

Thanks,

Ray