Re: [PATCH v6 07/19] i2c: octeon: Use i2c recovery framework

[Jan Glauber]

On Wed, Apr 20, 2016 at 11:31:21PM +0200, Wolfram Sang wrote:
> On Mon, Apr 11, 2016 at 05:28:38PM +0200, Jan Glauber wrote:
> > Switch to the i2c bus recovery framework using generic SCL recovery.
> > If this fails try to reset the hardware. The recovery is triggered
> > during START on timeout of the interrupt or failure to reach
> > the START / repeated-START condition.
> > 
> > The START function is moved to xfer and while at it:
> > - removed xfer debug message (i2c core already provides debugging)
> > - removed length is zero check
> > 
> > Signed-off-by: Jan Glauber <jglauber@xxxxxxxxxx>
> > ---
> >  drivers/i2c/busses/i2c-octeon.c | 178 +++++++++++++++++++++++++---------------
> >  1 file changed, 111 insertions(+), 67 deletions(-)
> 
> Interesting, it got larger...
> 
> > 
> > +/**
> > + * octeon_i2c_write_int - read the TWSI_INT register
> 
> read_int

OK

> > +	int ret, retries = 2;
> 
> I don't think 'retries' makes sense here. On failure, you return
> -EAGAIN, so the core will retry 'adapter->retries' times anyhow.

OK. I'll remove the retry looping and call recovery once
if the START condition is not reached. If recovery succeeds
I'll return -EAGAIN, otherwise the error code.

> > -	if (length < 1)
> > -		return -EINVAL;
> 
> So, the adapter support 0-length messages now? Or why was it there? I
> have the feeling this is a seperate patch.

I assumed this check was bogus and there are no valid 0-length
messages...
If 0-length messages can indeed happen I'll keep this check (but why
would the i2c core not check for that in a central place and return
an error before calling xfer() ?).

> > +static void octeon_i2c_prepare_recovery(struct i2c_adapter *adap)
> > +{
> > +	struct octeon_i2c *i2c = i2c_get_adapdata(adap);
> > +
> > +	/*
> > +	 * The stop resets the state machine, does not _transmit_ STOP unless
> > +	 * engine was active.
> > +	 */
> > +	octeon_i2c_stop(i2c);
> > +
> > +	octeon_i2c_write_int(i2c, 0);
> 
> Maybe a comment why the delay?

Later patch "Flush TWSI writes with readback" adds synchronization after
octeon_i2c_write_int(), so the delays in prepare/unprepare_recovery can
go away.

> > +	udelay(5);
> > +}