Re: [PATCH net v2 1/3] drivers: net: cpsw: fix parsing of phy-handle DT property in dual_emac config

From: Grygorii Strashko
Date: Fri Apr 22 2016 - 09:03:48 EST


On 04/21/2016 09:19 PM, David Rivshin (Allworx) wrote:
From: David Rivshin <drivshin@xxxxxxxxxxx>

Commit 9e42f715264ff158478fa30eaed847f6e131366b ("drivers: net: cpsw: add
phy-handle parsing") saved the "phy-handle" phandle into a new cpsw_priv
field. However, phy connections are per-slave, so the phy_node field should
be in cpsw_slave_data rather than cpsw_priv.

This would go unnoticed in a single emac configuration. But in dual_emac
mode, the last "phy-handle" property parsed for either slave would be used
by both of them, causing them both to refer to the same phy_device.

Fixes: 9e42f715264f ("drivers: net: cpsw: add phy-handle parsing")
Signed-off-by: David Rivshin <drivshin@xxxxxxxxxxx>
Tested-by: Nicolas Chauvet <kwizart@xxxxxxxxx>
---
I would suggest this for -stable. It should apply cleanly as far back
as 4.4.

Changes since v1 [1]:
- Rebased (no conflicts)
- Added Tested-by from Nicolas Chauvet

[1] https://patchwork.ozlabs.org/patch/560326/

Reviewed-by: Grygorii Strashko <grygorii.strashko@xxxxxx>


drivers/net/ethernet/ti/cpsw.c | 13 ++++++-------
drivers/net/ethernet/ti/cpsw.h | 1 +
2 files changed, 7 insertions(+), 7 deletions(-)

diff --git a/drivers/net/ethernet/ti/cpsw.c b/drivers/net/ethernet/ti/cpsw.c
index 42fdfd4..d69cb3f 100644
--- a/drivers/net/ethernet/ti/cpsw.c
+++ b/drivers/net/ethernet/ti/cpsw.c
@@ -363,15 +363,14 @@ static inline void slave_write(struct cpsw_slave *slave, u32 val, u32 offset)
__raw_writel(val, slave->regs + offset);
}

struct cpsw_priv {
spinlock_t lock;
struct platform_device *pdev;
struct net_device *ndev;
- struct device_node *phy_node;
struct napi_struct napi_rx;
struct napi_struct napi_tx;
struct device *dev;
struct cpsw_platform_data data;
struct cpsw_ss_regs __iomem *regs;
struct cpsw_wr_regs __iomem *wr_regs;
u8 __iomem *hw_stats;
@@ -1144,16 +1143,16 @@ static void cpsw_slave_open(struct cpsw_slave *slave, struct cpsw_priv *priv)

if (priv->data.dual_emac)
cpsw_add_dual_emac_def_ale_entries(priv, slave, slave_port);
else
cpsw_ale_add_mcast(priv->ale, priv->ndev->broadcast,
1 << slave_port, 0, 0, ALE_MCAST_FWD_2);

- if (priv->phy_node)
- slave->phy = of_phy_connect(priv->ndev, priv->phy_node,
+ if (slave->data->phy_node)
+ slave->phy = of_phy_connect(priv->ndev, slave->data->phy_node,
&cpsw_adjust_link, 0, slave->data->phy_if);
else
slave->phy = phy_connect(priv->ndev, slave->data->phy_id,
&cpsw_adjust_link, slave->data->phy_if);
if (IS_ERR(slave->phy)) {
dev_err(priv->dev, "phy %s not found on slave %d\n",
slave->data->phy_id, slave->slave_num);
@@ -1936,20 +1935,19 @@ static void cpsw_slave_init(struct cpsw_slave *slave, struct cpsw_priv *priv,

slave->data = data;
slave->regs = regs + slave_reg_ofs;
slave->sliver = regs + sliver_reg_ofs;
slave->port_vlan = data->dual_emac_res_vlan;
}

-static int cpsw_probe_dt(struct cpsw_priv *priv,
+static int cpsw_probe_dt(struct cpsw_platform_data *data,
struct platform_device *pdev)
{
struct device_node *node = pdev->dev.of_node;
struct device_node *slave_node;
- struct cpsw_platform_data *data = &priv->data;
int i = 0, ret;
u32 prop;

if (!node)
return -EINVAL;

if (of_property_read_u32(node, "slaves", &prop)) {
@@ -2029,15 +2027,16 @@ static int cpsw_probe_dt(struct cpsw_priv *priv,
int lenp;
const __be32 *parp;

/* This is no slave child node, continue */
if (strcmp(slave_node->name, "slave"))
continue;

- priv->phy_node = of_parse_phandle(slave_node, "phy-handle", 0);
+ slave_data->phy_node = of_parse_phandle(slave_node,
+ "phy-handle", 0);
parp = of_get_property(slave_node, "phy_id", &lenp);
if (of_phy_is_fixed_link(slave_node)) {
struct device_node *phy_node;
struct phy_device *phy_dev;

/* In the case of a fixed PHY, the DT node associated
* to the PHY is the Ethernet MAC DT node.
@@ -2271,15 +2270,15 @@ static int cpsw_probe(struct platform_device *pdev)
* This may be required here for child devices.
*/
pm_runtime_enable(&pdev->dev);

/* Select default pin state */
pinctrl_pm_select_default_state(&pdev->dev);

- if (cpsw_probe_dt(priv, pdev)) {
+ if (cpsw_probe_dt(&priv->data, pdev)) {
dev_err(&pdev->dev, "cpsw: platform data missing\n");
ret = -ENODEV;
goto clean_runtime_disable_ret;
}
data = &priv->data;

if (is_valid_ether_addr(data->slave_data[0].mac_addr)) {
diff --git a/drivers/net/ethernet/ti/cpsw.h b/drivers/net/ethernet/ti/cpsw.h
index 442a703..e50afd1 100644
--- a/drivers/net/ethernet/ti/cpsw.h
+++ b/drivers/net/ethernet/ti/cpsw.h
@@ -14,14 +14,15 @@
#ifndef __CPSW_H__
#define __CPSW_H__

#include <linux/if_ether.h>
#include <linux/phy.h>

struct cpsw_slave_data {
+ struct device_node *phy_node;
char phy_id[MII_BUS_ID_SIZE];
int phy_if;
u8 mac_addr[ETH_ALEN];
u16 dual_emac_res_vlan; /* Reserved VLAN for DualEMAC */
};

struct cpsw_platform_data {



--
regards,
-grygorii