[PATCH 1/3] net-next: mediatek: fix gigabit and flow control advertisement
From: John Crispin
Date: Thu May 05 2016 - 05:24:44 EST
The current code will not setup the PHYs advertisement features correctly.
Fix this and properly advertise Gigabit features and properly handle
asymmetric pause frames.
Signed-off-by: John Crispin <john@xxxxxxxxxxx>
---
drivers/net/ethernet/mediatek/mtk_eth_soc.c | 16 ++++++++++++++--
1 file changed, 14 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/mediatek/mtk_eth_soc.c b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
index c984462..093073c 100644
--- a/drivers/net/ethernet/mediatek/mtk_eth_soc.c
+++ b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
@@ -133,6 +133,8 @@ static int mtk_mdio_read(struct mii_bus *bus, int phy_addr, int phy_reg)
static void mtk_phy_link_adjust(struct net_device *dev)
{
struct mtk_mac *mac = netdev_priv(dev);
+ u16 lcl_adv, rmt_adv = 0;
+ u8 flowctrl;
u32 mcr = MAC_MCR_MAX_RX_1536 | MAC_MCR_IPG_CFG |
MAC_MCR_FORCE_MODE | MAC_MCR_TX_EN |
MAC_MCR_RX_EN | MAC_MCR_BACKOFF_EN |
@@ -154,7 +156,16 @@ static void mtk_phy_link_adjust(struct net_device *dev)
mcr |= MAC_MCR_FORCE_DPX;
if (mac->phy_dev->pause)
- mcr |= MAC_MCR_FORCE_RX_FC | MAC_MCR_FORCE_TX_FC;
+ rmt_adv = LPA_PAUSE_CAP;
+ if (mac->phy_dev->asym_pause)
+ rmt_adv |= LPA_PAUSE_ASYM;
+
+ lcl_adv = mii_advertise_flowctrl(FLOW_CTRL_RX | FLOW_CTRL_TX);
+ flowctrl = mii_resolve_flowctrl_fdx(lcl_adv, rmt_adv);
+ if (flowctrl & FLOW_CTRL_TX)
+ mcr |= MAC_MCR_FORCE_TX_FC;
+ if (flowctrl & FLOW_CTRL_RX)
+ mcr |= MAC_MCR_FORCE_RX_FC;
mtk_w32(mac->hw, mcr, MTK_MAC_MCR(mac->id));
@@ -236,7 +247,8 @@ static int mtk_phy_connect(struct mtk_mac *mac)
mac->phy_dev->autoneg = AUTONEG_ENABLE;
mac->phy_dev->speed = 0;
mac->phy_dev->duplex = 0;
- mac->phy_dev->supported &= PHY_BASIC_FEATURES;
+ mac->phy_dev->supported &= PHY_GBIT_FEATURES | SUPPORTED_Pause |
+ ~SUPPORTED_Asym_Pause;
mac->phy_dev->advertising = mac->phy_dev->supported |
ADVERTISED_Autoneg;
phy_start_aneg(mac->phy_dev);
--
1.7.10.4