[RFC v2 10/13] usb: hub: Power sequence the ports on activation

[Krzysztof Kozlowski]

The autodetection of attached USB device might not work on certain
boards where the power is delivered externally. These devices also might
require a hard reset. Use pwrseq for that in USB hub.

Signed-off-by: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
---
 drivers/usb/core/hub.c | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
index 1c82fcc448f5..0fddaacc62bf 100644
--- a/drivers/usb/core/hub.c
+++ b/drivers/usb/core/hub.c
@@ -26,6 +26,7 @@
 #include <linux/mutex.h>
 #include <linux/random.h>
 #include <linux/pm_qos.h>
+#include <linux/pwrseq.h>
 
 #include <asm/uaccess.h>
 #include <asm/byteorder.h>
@@ -1661,7 +1662,17 @@ static int hub_configure(struct usb_hub *hub,
 
 	usb_hub_adjust_deviceremovable(hdev, hub->descriptor);
 
+	/* FIXME: When do the pre-power-on? */
+	/*
+	for (i = 0; i < maxchild; i++)
+		pwrseq_pre_power_on(hub->ports[i]->pwrseq);
+	*/
+
+	for (i = 0; i < maxchild; i++)
+		pwrseq_post_power_on(hub->ports[i]->pwrseq);
+
 	hub_activate(hub, HUB_INIT);
+
 	return 0;
 
 fail:
-- 
1.9.1