Re: [PATCH v7 3/5] usb: dwc3: omap: Don't set POWERPRESENT

[Roger Quadros]

On 10/05/16 12:54, Felipe Balbi wrote:
> 
> Hi,
> 
> Roger Quadros <rogerq@xxxxxx> writes:
>> TRM [1] recommends that POWERPRESENT bit must not be
>> set and left at it's default value of 0.
>>
>> [1] OMAP542x TRM - http://www.ti.com/lit/pdf/swpu249
>> Section 23.11.4.5.1 Mailbox VBUS/ID Management
>>
>> "Because PIPE powerpresent has a different meaning in host and in device mode,
>> and because of the redundancy with the UTMI signals, the controller ORes
>> together the appropriate PIPE and UTMI inputs to create its internal
>> VBUS status. For that reason, it is recommended to leave field
>> USBOTGSS_UTMI_OTG_STATUS[9] POWERPRESENT at its default value (=0), and only to
>> fill in the USB2 VBUS status fields in the same register."
>>
>> Signed-off-by: Roger Quadros <rogerq@xxxxxx>
> 
> to make sure we avoid regressions, do you mind sharing on which
> platforms you tested this patch ?
> 
I tested this on omap5-uevm and dra7-evm.
My am437x board stopped working so couldn't test on that one.

cheers,
-roger