Re: [PATCH v8 2/2] memory: atmel-ebi: add DT bindings documentation
From: Rob Herring
Date: Mon May 16 2016 - 10:59:30 EST
On Wed, May 11, 2016 at 12:13:08PM +0200, Boris Brezillon wrote:
> The EBI (External Bus Interface) is used to access external peripherals
> (NOR, SRAM, NAND, and other specific devices like ethernet controllers).
> Each device is assigned a CS line and an address range and can have its
> own configuration (timings, access mode, bus width, ...).
> This driver provides a generic DT binding to configure a device according
> to its requirements.
> For specific device controllers (like the NAND one) the SMC timings
> should be configured by the controller driver through the matrix and smc
> syscon regmaps.
>
> Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxxxxxxx>
> ---
> .../bindings/memory-controllers/atmel,ebi.txt | 136 +++++++++++++++++++++
> 1 file changed, 136 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/memory-controllers/atmel,ebi.txt
>
> diff --git a/Documentation/devicetree/bindings/memory-controllers/atmel,ebi.txt b/Documentation/devicetree/bindings/memory-controllers/atmel,ebi.txt
> new file mode 100644
> index 0000000..2fe9b5b
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/memory-controllers/atmel,ebi.txt
> @@ -0,0 +1,136 @@
[...]
> +Children device nodes are representing device connected to the EBI bus.
> +
> +Required device node properties:
> +
> +- #reg: Contains the chip-select id, the offset and the length
Still need to fix #reg.
Otherwise,
Acked-by: Rob Herring <robh@xxxxxxxxxx>