RE: [PATCH 05/14] staging: comedi: daqboard2000: rename serial EEPROM register macros

[Hartley Sweeten]

On Tuesday, May 17, 2016 2:53 AM, Ian Abbott wrote:
> Rename the macros defining values for the Serial EEPROM Control Register
> to avoid CamelCase.
>
> Signed-off-by: Ian Abbott <abbotti@xxxxxxxxx>
> ---
>  drivers/staging/comedi/drivers/daqboard2000.c | 26 +++++++++++++-------------
>  1 file changed, 13 insertions(+), 13 deletions(-)
>
> diff --git a/drivers/staging/comedi/drivers/daqboard2000.c b/drivers/staging/comedi/drivers/daqboard2000.c
> index fde0924..b3b68e8 100644
> --- a/drivers/staging/comedi/drivers/daqboard2000.c
> +++ b/drivers/staging/comedi/drivers/daqboard2000.c
> @@ -116,12 +116,12 @@
>  #define DAQBOARD2000_SUBSYSTEM_IDS4	0x0004	/* Daqboard/2000 - 4 Dacs */

Ian,

This board uses a PLX-9080 chip for the PCI interface.

If would be better to include <plx9080.h> and use the register/bit defines
to remove the magic numbers.

The only PLX register used is PLX_CONTROL_REG (0x6c).

>  /* Initialization bits for the Serial EEPROM Control Register */
> -#define DAQBOARD2000_SECRProgPinHi      0x8001767e
> -#define DAQBOARD2000_SECRProgPinLo      0x8000767e
> -#define DAQBOARD2000_SECRLocalBusHi     0xc000767e
> -#define DAQBOARD2000_SECRLocalBusLo     0x8000767e
> -#define DAQBOARD2000_SECRReloadHi       0xa000767e
> -#define DAQBOARD2000_SECRReloadLo       0x8000767e
> +#define DAQBOARD2000_SECR_PROG_PIN_HI	0x8001767e
> +#define DAQBOARD2000_SECR_PROG_PIN_LO	0x8000767e
> +#define DAQBOARD2000_SECR_LOCAL_BUS_HI	0xc000767e
> +#define DAQBOARD2000_SECR_LOCAL_BUS_LO	0x8000767e
> +#define DAQBOARD2000_SECR_RELOAD_HI	0xa000767e
> +#define DAQBOARD2000_SECR_RELOAD_LO	0x8000767e

These "Initialization bits" are just various combinations of the
PLX_CONTROL_REG bit defines (CTL_*) to toggle the various
EEPROM bits.
 
>  /* SECR status bits */
>  #define DAQBOARD2000_EEPROM_PRESENT     0x10000000
> @@ -438,9 +438,9 @@ static void daqboard2000_resetLocalBus(struct comedi_device *dev)
>  {
>  	struct daqboard2000_private *devpriv = dev->private;
>  
> -	writel(DAQBOARD2000_SECRLocalBusHi, devpriv->plx + 0x6c);
> +	writel(DAQBOARD2000_SECR_LOCAL_BUS_HI, devpriv->plx + 0x6c);
>  	mdelay(10);
> -	writel(DAQBOARD2000_SECRLocalBusLo, devpriv->plx + 0x6c);
> +	writel(DAQBOARD2000_SECR_LOCAL_BUS_LO, devpriv->plx + 0x6c);
>  	mdelay(10);
>  }
>  
> @@ -448,11 +448,11 @@ static void daqboard2000_reloadPLX(struct comedi_device *dev)
>  {
>  	struct daqboard2000_private *devpriv = dev->private;
>  
> -	writel(DAQBOARD2000_SECRReloadLo, devpriv->plx + 0x6c);
> +	writel(DAQBOARD2000_SECR_RELOAD_LO, devpriv->plx + 0x6c);
>  	mdelay(10);
> -	writel(DAQBOARD2000_SECRReloadHi, devpriv->plx + 0x6c);
> +	writel(DAQBOARD2000_SECR_RELOAD_HI, devpriv->plx + 0x6c);
>  	mdelay(10);
> -	writel(DAQBOARD2000_SECRReloadLo, devpriv->plx + 0x6c);
> +	writel(DAQBOARD2000_SECR_RELOAD_LO, devpriv->plx + 0x6c);
>  	mdelay(10);
>  }
 >
> @@ -460,9 +460,9 @@ static void daqboard2000_pulseProgPin(struct comedi_device *dev)
>  {
>  	struct daqboard2000_private *devpriv = dev->private;
>  
> -	writel(DAQBOARD2000_SECRProgPinHi, devpriv->plx + 0x6c);
> +	writel(DAQBOARD2000_SECR_PROG_PIN_HI, devpriv->plx + 0x6c);
>  	mdelay(10);
> -	writel(DAQBOARD2000_SECRProgPinLo, devpriv->plx + 0x6c);
> +	writel(DAQBOARD2000_SECR_PROG_PIN_LO, devpriv->plx + 0x6c);
>  	mdelay(10);	/* Not in the original code, but I like symmetry... */
>  }

Regards,
Hartley