Re: [PATCH v2] mmc: sdhci: fix wakeup configuration

From: Adrian Hunter
Date: Fri May 20 2016 - 14:29:07 EST


On 20/05/2016 4:39 p.m., Ulf Hansson wrote:
On 20 May 2016 at 13:46, Adrian Hunter <adrian.hunter@xxxxxxxxx> wrote:
On 13/05/16 16:16, Ludovic Desroches wrote:
Activating wakeup event is not enough to get a wakeup signal. The
corresponding events have to be enabled in the Interrupt Status Enable
Register too. It follows the specification and is needed at least by
sdhci-of-at91.

Signed-off-by: Ludovic Desroches <ludovic.desroches@xxxxxxxxx>

Acked-by: Adrian Hunter <adrian.hunter@xxxxxxxxx>

Is this material for stable and as a fix for 4.6?

Not as far as I know.


Kind regards
Uffe



---
drivers/mmc/host/sdhci.c | 15 ++++++++++++++-
1 file changed, 14 insertions(+), 1 deletion(-)

Changes:
- v2:
- update commit message and comments
- do not rename val and mask variables

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index e010ea4..e351859 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -2605,18 +2605,31 @@ static irqreturn_t sdhci_thread_irq(int irq, void *dev_id)
\*****************************************************************************/

#ifdef CONFIG_PM
+/*
+ * To enable wakeup events, the corresponding events have to be enabled in
+ * the Interrupt Status Enable register too. See 'Table 1-6: Wakeup Signal
+ * Table' in the SD Host Controller Standard Specification.
+ * It is useless to restore SDHCI_INT_ENABLE state in
+ * sdhci_disable_irq_wakeups() since it will be set by
+ * sdhci_enable_card_detection() or sdhci_init().
+ */
void sdhci_enable_irq_wakeups(struct sdhci_host *host)
{
u8 val;
u8 mask = SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE
| SDHCI_WAKE_ON_INT;
+ u32 irq_val = SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE |
+ SDHCI_INT_CARD_INT;

val = sdhci_readb(host, SDHCI_WAKE_UP_CONTROL);
val |= mask ;
/* Avoid fake wake up */
- if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION)
+ if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION) {
val &= ~(SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE);
+ irq_val &= ~(SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE);
+ }
sdhci_writeb(host, val, SDHCI_WAKE_UP_CONTROL);
+ sdhci_writel(host, irq_val, SDHCI_INT_ENABLE);
}
EXPORT_SYMBOL_GPL(sdhci_enable_irq_wakeups);