Re: [PATCH v2] mmc: sdhci: fix wakeup configuration

From: Ludovic Desroches
Date: Thu May 26 2016 - 08:30:24 EST


On Fri, May 20, 2016 at 09:28:56PM +0300, Adrian Hunter wrote:
> On 20/05/2016 4:39 p.m., Ulf Hansson wrote:
> > On 20 May 2016 at 13:46, Adrian Hunter <adrian.hunter@xxxxxxxxx> wrote:
> > > On 13/05/16 16:16, Ludovic Desroches wrote:
> > > > Activating wakeup event is not enough to get a wakeup signal. The
> > > > corresponding events have to be enabled in the Interrupt Status Enable
> > > > Register too. It follows the specification and is needed at least by
> > > > sdhci-of-at91.
> > > >
> > > > Signed-off-by: Ludovic Desroches <ludovic.desroches@xxxxxxxxx>
> > >
> > > Acked-by: Adrian Hunter <adrian.hunter@xxxxxxxxx>
> >
> > Is this material for stable and as a fix for 4.6?
>
> Not as far as I know.
>

System PM code for the Atmel SDHCI has not been submitted yet so no need
to take it as a fix.

Regards

Ludovic

> >
> > Kind regards
> > Uffe
> >
> > >
> > >
> > > > ---
> > > > drivers/mmc/host/sdhci.c | 15 ++++++++++++++-
> > > > 1 file changed, 14 insertions(+), 1 deletion(-)
> > > >
> > > > Changes:
> > > > - v2:
> > > > - update commit message and comments
> > > > - do not rename val and mask variables
> > > >
> > > > diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
> > > > index e010ea4..e351859 100644
> > > > --- a/drivers/mmc/host/sdhci.c
> > > > +++ b/drivers/mmc/host/sdhci.c
> > > > @@ -2605,18 +2605,31 @@ static irqreturn_t sdhci_thread_irq(int irq, void *dev_id)
> > > > \*****************************************************************************/
> > > >
> > > > #ifdef CONFIG_PM
> > > > +/*
> > > > + * To enable wakeup events, the corresponding events have to be enabled in
> > > > + * the Interrupt Status Enable register too. See 'Table 1-6: Wakeup Signal
> > > > + * Table' in the SD Host Controller Standard Specification.
> > > > + * It is useless to restore SDHCI_INT_ENABLE state in
> > > > + * sdhci_disable_irq_wakeups() since it will be set by
> > > > + * sdhci_enable_card_detection() or sdhci_init().
> > > > + */
> > > > void sdhci_enable_irq_wakeups(struct sdhci_host *host)
> > > > {
> > > > u8 val;
> > > > u8 mask = SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE
> > > > | SDHCI_WAKE_ON_INT;
> > > > + u32 irq_val = SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE |
> > > > + SDHCI_INT_CARD_INT;
> > > >
> > > > val = sdhci_readb(host, SDHCI_WAKE_UP_CONTROL);
> > > > val |= mask ;
> > > > /* Avoid fake wake up */
> > > > - if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION)
> > > > + if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION) {
> > > > val &= ~(SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE);
> > > > + irq_val &= ~(SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE);
> > > > + }
> > > > sdhci_writeb(host, val, SDHCI_WAKE_UP_CONTROL);
> > > > + sdhci_writel(host, irq_val, SDHCI_INT_ENABLE);
> > > > }
> > > > EXPORT_SYMBOL_GPL(sdhci_enable_irq_wakeups);
> > > >
> > > >
> > >