Re: [PATCH 3/7] binding: mdio-mux: Add DT binding doc for Broadcom MDIO bus mutiplexer

[Andrew Lunn]

On Mon, May 30, 2016 at 12:40:47PM +0530, Pramod Kumar wrote:
> Add DT binding doc for Broadcom MDIO bus mutiplexer driver.
> 
> Signed-off-by: Pramod Kumar <pramod.kumar@xxxxxxxxxxxx>
> ---
>  .../bindings/net/brcm,mdio-mux-iproc.txt           | 64 ++++++++++++++++++++++
>  1 file changed, 64 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/net/brcm,mdio-mux-iproc.txt
> 
> diff --git a/Documentation/devicetree/bindings/net/brcm,mdio-mux-iproc.txt b/Documentation/devicetree/bindings/net/brcm,mdio-mux-iproc.txt
> new file mode 100644
> index 0000000..dd74ee0
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/brcm,mdio-mux-iproc.txt
> @@ -0,0 +1,64 @@
> +Properties for an MDIO bus mutiplexer found in Broadcom iProc based SoCs.
> +
> +This MDIO bus multiplexer defines buses that could be internal as well as
> +external to SoCs and could accept MDIO transaction compatible to C-22 or
> +C-45 Clause. When Child bus is selected, one need to select these two
> +properties as well to generate desired MDIO trascation on appropriate bus.
> +
> +Required properties in addition to the generic multiplexer properties:
> +
> +MDIO multiplexer node:
> +- complatible: brcm,mdio-mux-iproc.
> +
> +Child bus node:
> +-brcm,is-c45: Boolean property indicating PHYs attached to this bus supports
> +	      C-45 mdio transaction.

This is-c45 seems to be at the wrong level. As far as i know, you can
mix C22 and C45 devices on a bus. It is a property of the individual
MDIO device if it uses C45 or not.

I would expect your MDIO device PHY drivers to logically OR
MII_ADDR_C45 into the address when doing an MDIO read/write using C45.

	     Andrew