Re: lm-senser can't detect thermal on thermal_zone

[Kuninori Morimoto]

Hi Zhang

Can you check this email ?

> > Thank you for your help
> > 
> > > > 	non thermal-zon
> > > > 	  sensor command: OK
> > > > 	  read from /sys/class/thermal/thermal_zone0 : OK
> > > > 
> > > > 	thermal-zon
> > > > 	  sensor command: NG
> > > > 	  read from /sys/class/thermal/thermal_zone0 : OK
> > > 
> > > config THERMAL_HWMON
> > >         bool
> > >         prompt "Expose thermal sensors as hwmon device"
> > >         depends on HWMON=y || HWMON=THERMAL
> > >         default y
> > > 
> > > please check if the thermal subsystem is built in, while hwmon subsystem
> > > is built as module.
> > > you should either set CONFIG_HWMON=y, or set both CONFIG_HWMON and
> > > CONFIG_THERMAL as module.
> > 
> > Thanks. but it seems our system has it.
> > 
> > I noticed that thermal_zone case uses of_parse_thermal_zones()
> > and it has this.
> > 
> > 		/* No hwmon because there might be hwmon drivers registering */
> > 		tzp->no_hwmon = true;
> > 
> > and on thermal_zone_device_register() check this for hwmon
> > 
> > struct thermal_zone_device *thermal_zone_device_register(xxxx)
> > {
> > 	...
> > 	if (!tz->tzp || !tz->tzp->no_hwmon) {
> > 		result = thermal_add_hwmon_sysfs(tz);
> > 		...
> > 	}
> > 	...
> > }
> > 
> > Does this mean "thermal_zone doesn't use lm-senser" ?
> 
> 
> Best regards
> ---
> Kuninori Morimoto