Re: [PATCH v2 1/2] Documentation: bindings: add dt doc for Rockchip PCIe controller

[Doug Anderson]

Shawn,

On Wed, Jun 8, 2016 at 1:05 AM, Shawn Lin <shawn.lin@xxxxxxxxxxxxxx> wrote:
> +pcie0: pcie@f8000000 {
> +       compatible = "rockchip,rk3399-pcie";
> +       #address-cells = <3>;
> +       #size-cells = <2>;
> +       clocks = <&cru ACLK_PCIE>, <&cru ACLK_PERF_PCIE>,
> +                <&cru PCLK_PCIE>;
> +       clock-names = "aclk", "aclk-perf",
> +                     "hclk";

Code also requires a "pm" clock.

> +       bus-range = <0x0 0x1>;
> +       interrupts = <GIC_SPI 49 IRQ_TYPE_LEVEL_HIGH>, <GIC_SPI 50 IRQ_TYPE_LEVEL_HIGH>,
> +                    <GIC_SPI 51 IRQ_TYPE_LEVEL_HIGH>;
> +       interrupt-names: "sys", "legacy", "client";

Shouldn't be ":", should be "=".


> +       assigned-clocks = <&cru SCLK_PCIEPHY_REF>;
> +       assigned-clock-parents = <&cru SCLK_PCIEPHY_REF100M>;
> +       assigned-clock-rates = <100000000>;
> +       ep-gpios = <&gpio3 13 GPIO_ACTIVE_HIGH>;
> +       ranges = < 0x82000000 0 0xfa000000 0x0 0xfa000000 0 0x600000
> +                  0x81000000 0 0xfa600000 0x0 0xfa600000 0 0x100000 >;

nit: I don't thin it's common to have spaces before/after the ">" and "<".
nit: Be consistent about 0 vs. 0x0 in ranges.


> +       num-lanes = <4>;
> +       reg = < 0x0 0xf8000000 0x0 0x2000000 >, < 0x0 0xfd000000 0x0 0x1000000 >;
> +       reg-name = "axi-base", "apb-base";

Should be "reg-names" (with an "s")


> +       resets = <&cru SRST_PCIEPHY>, <&cru SRST_PCIE_CORE>, <&cru SRST_PCIE_MGMT>,
> +                <&cru SRST_PCIE_MGMT_STICKY>, <&cru SRST_PCIE_PIPE>;
> +       reset-names = "core", "mgmt", "mgmt-sticky", "pipe";

You have 5 resets but 4 reset names.  That doesn't seem right.  Code
shows you only getting 4, so presumably you need to remove the
SRST_PCIEPHY one.


-Doug