RE: [PATCH V4 3/3] i2c: qup: Fix error handling
From: Sricharan
Date: Fri Jun 10 2016 - 14:16:08 EST
+Wolfram Sang
>-----Original Message-----
>From: linux-arm-kernel [mailto:linux-arm-kernel-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Sricharan R
>Sent: Friday, June 10, 2016 11:38 PM
>To: linux-arm-msm@xxxxxxxxxxxxxxx; ntelkar@xxxxxxxxxxxxxx; galak@xxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx;
>andy.gross@xxxxxxxxxx; linux-i2c@xxxxxxxxxxxxxxx; agross@xxxxxxxxxxxxxx; linux-arm-kernel@xxxxxxxxxxxxxxxxxxx;
>nkaje@xxxxxxxxxxxxxx; absahu@xxxxxxxxxxxxxx
>Cc: sricharan@xxxxxxxxxxxxxx
>Subject: [PATCH V4 3/3] i2c: qup: Fix error handling
>
>Among the bus errors reported from the QUP_MASTER_STATUS register
>only NACK is considered and transfer gets suspended, while
>other errors are ignored. Correct this and suspend the transfer
>for other errors as well. This avoids unnecessary 'timeouts' which
>happens when waiting for events that would never happen when there
>is already an error condition on the bus. Also the error handling
>procedure should be the same for both NACK and other bus errors in
>case of dma mode. So correct that as well.
>
>Signed-off-by: Sricharan R <sricharan@xxxxxxxxxxxxxx>
>---
> drivers/i2c/busses/i2c-qup.c | 76 ++++++++++++++++++++++++--------------------
> 1 file changed, 41 insertions(+), 35 deletions(-)
>
>diff --git a/drivers/i2c/busses/i2c-qup.c b/drivers/i2c/busses/i2c-qup.c
>index b8116e5..44c80ae 100644
>--- a/drivers/i2c/busses/i2c-qup.c
>+++ b/drivers/i2c/busses/i2c-qup.c
>@@ -310,6 +310,7 @@ static int qup_i2c_wait_ready(struct qup_i2c_dev *qup, int op, bool val,
> u32 opflags;
> u32 status;
> u32 shift = __ffs(op);
>+ int ret = 0;
>
> len *= qup->one_byte_t;
> /* timeout after a wait of twice the max time */
>@@ -321,18 +322,28 @@ static int qup_i2c_wait_ready(struct qup_i2c_dev *qup, int op, bool val,
>
> if (((opflags & op) >> shift) == val) {
> if ((op == QUP_OUT_NOT_EMPTY) && qup->is_last) {
>- if (!(status & I2C_STATUS_BUS_ACTIVE))
>- return 0;
>+ if (!(status & I2C_STATUS_BUS_ACTIVE)) {
>+ ret = 0;
>+ goto done;
>+ }
> } else {
>- return 0;
>+ ret = 0;
>+ goto done;
> }
> }
>
>- if (time_after(jiffies, timeout))
>- return -ETIMEDOUT;
>-
>+ if (time_after(jiffies, timeout)) {
>+ ret = -ETIMEDOUT;
>+ goto done;
>+ }
> usleep_range(len, len * 2);
> }
>+
>+done:
>+ if (qup->bus_err || qup->qup_err)
>+ ret = (qup->bus_err & QUP_I2C_NACK_FLAG) ? -ENXIO : -EIO;
>+
>+ return ret;
> }
>
> static void qup_i2c_set_write_mode_v2(struct qup_i2c_dev *qup,
>@@ -793,39 +804,35 @@ static int qup_i2c_bam_do_xfer(struct qup_i2c_dev *qup, struct i2c_msg *msg,
> }
>
> if (ret || qup->bus_err || qup->qup_err) {
>- if (qup->bus_err & QUP_I2C_NACK_FLAG) {
>- msg--;
>- dev_err(qup->dev, "NACK from %x\n", msg->addr);
>- ret = -EIO;
>+ if (qup_i2c_change_state(qup, QUP_RUN_STATE)) {
>+ dev_err(qup->dev, "change to run state timed out");
>+ goto desc_err;
>+ }
>
>- if (qup_i2c_change_state(qup, QUP_RUN_STATE)) {
>- dev_err(qup->dev, "change to run state timed out");
>- return ret;
>- }
>+ if (rx_nents)
>+ writel(QUP_BAM_INPUT_EOT,
>+ qup->base + QUP_OUT_FIFO_BASE);
>
>- if (rx_nents)
>- writel(QUP_BAM_INPUT_EOT,
>- qup->base + QUP_OUT_FIFO_BASE);
>+ writel(QUP_BAM_FLUSH_STOP, qup->base + QUP_OUT_FIFO_BASE);
>
>- writel(QUP_BAM_FLUSH_STOP,
>- qup->base + QUP_OUT_FIFO_BASE);
>+ qup_i2c_flush(qup);
>
>- qup_i2c_flush(qup);
>+ /* wait for remaining interrupts to occur */
>+ if (!wait_for_completion_timeout(&qup->xfer, HZ))
>+ dev_err(qup->dev, "flush timed out\n");
>
>- /* wait for remaining interrupts to occur */
>- if (!wait_for_completion_timeout(&qup->xfer, HZ))
>- dev_err(qup->dev, "flush timed out\n");
>+ qup_i2c_rel_dma(qup);
>
>- qup_i2c_rel_dma(qup);
>- }
>+ ret = (qup->bus_err & QUP_I2C_NACK_FLAG) ? -ENXIO : -EIO;
> }
>
>+desc_err:
> dma_unmap_sg(qup->dev, qup->btx.sg, tx_nents, DMA_TO_DEVICE);
>
> if (rx_nents)
> dma_unmap_sg(qup->dev, qup->brx.sg, rx_nents,
> DMA_FROM_DEVICE);
>-desc_err:
>+
> return ret;
> }
>
>@@ -841,9 +848,6 @@ static int qup_i2c_bam_xfer(struct i2c_adapter *adap, struct i2c_msg *msg,
> if (ret)
> goto out;
>
>- qup->bus_err = 0;
>- qup->qup_err = 0;
>-
> writel(0, qup->base + QUP_MX_INPUT_CNT);
> writel(0, qup->base + QUP_MX_OUTPUT_CNT);
>
>@@ -881,12 +885,8 @@ static int qup_i2c_wait_for_complete(struct qup_i2c_dev *qup,
> ret = -ETIMEDOUT;
> }
>
>- if (qup->bus_err || qup->qup_err) {
>- if (qup->bus_err & QUP_I2C_NACK_FLAG) {
>- dev_err(qup->dev, "NACK from %x\n", msg->addr);
>- ret = -EIO;
>- }
>- }
>+ if (qup->bus_err || qup->qup_err)
>+ ret = (qup->bus_err & QUP_I2C_NACK_FLAG) ? -ENXIO : -EIO;
>
> return ret;
> }
>@@ -1178,6 +1178,9 @@ static int qup_i2c_xfer(struct i2c_adapter *adap,
> if (ret < 0)
> goto out;
>
>+ qup->bus_err = 0;
>+ qup->qup_err = 0;
>+
> writel(1, qup->base + QUP_SW_RESET);
> ret = qup_i2c_poll_state(qup, QUP_RESET_STATE);
> if (ret)
>@@ -1227,6 +1230,9 @@ static int qup_i2c_xfer_v2(struct i2c_adapter *adap,
> struct qup_i2c_dev *qup = i2c_get_adapdata(adap);
> int ret, len, idx = 0, use_dma = 0;
>
>+ qup->bus_err = 0;
>+ qup->qup_err = 0;
>+
> ret = pm_runtime_get_sync(qup->dev);
> if (ret < 0)
> goto out;
>--
>QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux
>Foundation
>
>
>_______________________________________________
>linux-arm-kernel mailing list
>linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
>http://lists.infradead.org/mailman/listinfo/linux-arm-kernel