Re: [PATCH RFC 2/2] brcmfmac: support removing AP interfaces with "interface_remove"

[Arend van Spriel]

On 18-06-16 20:18, RafaÅ MiÅecki wrote:
> New firmwares (e.g. 10.10.69.36 for BCM4366) support "interface_remove"
> for removing interfaces. Try to use this method on cfg80211 request. In
> case of older firmwares (e.g. 7.35.177.56 for BCM43602 as I tested) this
> will just result in firmware rejecting command and this won't change any
> behavior.
> 
> Signed-off-by: RafaÅ MiÅecki <zajec5@xxxxxxxxx>
> ---
>  .../broadcom/brcm80211/brcmfmac/cfg80211.c         | 37 +++++++++++++++++++++-
>  1 file changed, 36 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
> index 502b0a0..aff76c2 100644
> --- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
> +++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
> @@ -785,12 +785,46 @@ s32 brcmf_notify_escan_complete(struct brcmf_cfg80211_info *cfg,
>  	return err;
>  }
>  
> +static int brcmf_cfg80211_del_ap_iface(struct wiphy *wiphy,
> +				       struct wireless_dev *wdev)
> +{
> +	struct brcmf_cfg80211_info *cfg = wiphy_priv(wiphy);
> +	struct net_device *ndev = wdev->netdev;
> +	struct brcmf_if *ifp = netdev_priv(ndev);
> +	int ret;
> +	int err;
> +
> +	brcmf_cfg80211_arm_vif_event(cfg, ifp->vif);
> +
> +	err = brcmf_fil_bsscfg_data_set(ifp, "interface_remove", NULL, 0);
> +	if (err) {
> +		brcmf_err("interface_remove failed %d\n", err);
> +		goto err_unarm;
> +	}
> +
> +	/* wait for firmware event */
> +	ret = brcmf_cfg80211_wait_vif_event(cfg, BRCMF_E_IF_DEL,
> +					    BRCMF_VIF_EVENT_TIMEOUT);
> +	if (!ret) {
> +		brcmf_err("timeout occurred\n");
> +		err = -EIO;
> +		goto err_unarm;
> +	}
> +
> +err_unarm:
> +	brcmf_cfg80211_arm_vif_event(cfg, NULL);
> +	return err;
> +}
> +
>  static
>  int brcmf_cfg80211_del_iface(struct wiphy *wiphy, struct wireless_dev *wdev)
>  {
>  	struct brcmf_cfg80211_info *cfg = wiphy_priv(wiphy);
>  	struct net_device *ndev = wdev->netdev;
>  
> +	if (ndev == cfg_to_ndev(cfg))

ndev can be NULL, ie. for IFTYPE_P2P_DEVICE.

Regards,
Arend

> +		return -ENOTSUPP;
> +
>  	/* vif event pending in firmware */
>  	if (brcmf_cfg80211_vif_event_armed(cfg))
>  		return -EBUSY;
> @@ -807,12 +841,13 @@ int brcmf_cfg80211_del_iface(struct wiphy *wiphy, struct wireless_dev *wdev)
>  	switch (wdev->iftype) {
>  	case NL80211_IFTYPE_ADHOC:
>  	case NL80211_IFTYPE_STATION:
> -	case NL80211_IFTYPE_AP:
>  	case NL80211_IFTYPE_AP_VLAN:
>  	case NL80211_IFTYPE_WDS:
>  	case NL80211_IFTYPE_MONITOR:
>  	case NL80211_IFTYPE_MESH_POINT:
>  		return -EOPNOTSUPP;
> +	case NL80211_IFTYPE_AP:
> +		return brcmf_cfg80211_del_ap_iface(wiphy, wdev);
>  	case NL80211_IFTYPE_P2P_CLIENT:
>  	case NL80211_IFTYPE_P2P_GO:
>  	case NL80211_IFTYPE_P2P_DEVICE:
>