[PATCH] spi: Fix typo in devicetree/bindings/spi
From: Masanari Iida
Date: Tue Jun 28 2016 - 15:33:33 EST
This patch fix spelling typos found in
Documentation/devicetree/bingings/spi.
Signed-off-by: Masanari Iida <standby24x7@xxxxxxxxx>
Signed-off-by: Mark Brown <broonie@xxxxxxxxxx>
---
Documentation/devicetree/bindings/spi/spi-davinci.txt | 2 +-
Documentation/devicetree/bindings/spi/ti_qspi.txt | 2 +-
2 files changed, 2 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/spi/spi-davinci.txt b/Documentation/devicetree/bindings/spi/spi-davinci.txt
index d1e914adcf6e..f5916c92fe91 100644
--- a/Documentation/devicetree/bindings/spi/spi-davinci.txt
+++ b/Documentation/devicetree/bindings/spi/spi-davinci.txt
@@ -21,7 +21,7 @@ Required properties:
IP to the interrupt controller within the SoC. Possible values
are 0 and 1. Manual says one of the two possible interrupt
lines can be tied to the interrupt controller. Set this
- based on a specifc SoC configuration.
+ based on a specific SoC configuration.
- interrupts: interrupt number mapped to CPU.
- clocks: spi clk phandle
diff --git a/Documentation/devicetree/bindings/spi/ti_qspi.txt b/Documentation/devicetree/bindings/spi/ti_qspi.txt
index 50b14f6b53a3..e65fde4a7388 100644
--- a/Documentation/devicetree/bindings/spi/ti_qspi.txt
+++ b/Documentation/devicetree/bindings/spi/ti_qspi.txt
@@ -20,7 +20,7 @@ Optional properties:
chipselect register and offset of that register.
NOTE: TI QSPI controller requires different pinmux and IODelay
-paramaters for Mode-0 and Mode-3 operations, which needs to be set up by
+parameters for Mode-0 and Mode-3 operations, which needs to be set up by
the bootloader (U-Boot). Default configuration only supports Mode-0
operation. Hence, "spi-cpol" and "spi-cpha" DT properties cannot be
specified in the slave nodes of TI QSPI controller without appropriate
--
2.8.1