[PATCH RESEND v2 3/8] tty: serial: fsl_lpuart: fix clearing of receive flag

[Bhuvanchandra DV]

From: Stefan Agner <stefan@xxxxxxxx>

Commit 8e4934c6d6c6 ("tty: serial: fsl_lpuart: clear receive flag on FIFO
flush") implemented clearing of the receive flag by reading the status register
only. It turned out that even though we flush the FIFO afterwards, a explicit
read of the data register is still required.

This leads to a FIFO underrun. To avoid this, follow the advice in the overrun
"Operation section": Unconditionally clear RXUF after using RXFLUSH.

Signed-off-by: Stefan Agner <stefan@xxxxxxxx>
Signed-off-by: Bhuvanchandra DV <bhuvanchandra.dv@xxxxxxxxxxx>
---
 drivers/tty/serial/fsl_lpuart.c | 9 ++++++---
 1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
index 75a2098..97c1fda 100644
--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -935,13 +935,16 @@ static void lpuart_setup_watermark(struct lpuart_port *sport)
 	writeb(val | UARTPFIFO_TXFE | UARTPFIFO_RXFE,
 			sport->port.membase + UARTPFIFO);
 
-	/* explicitly clear RDRF */
-	readb(sport->port.membase + UARTSR1);
-
 	/* flush Tx and Rx FIFO */
 	writeb(UARTCFIFO_TXFLUSH | UARTCFIFO_RXFLUSH,
 			sport->port.membase + UARTCFIFO);
 
+	/* explicitly clear RDRF */
+	if (readb(sport->port.membase + UARTSR1) & UARTSR1_RDRF) {
+		readb(sport->port.membase + UARTDR);
+		writeb(UARTSFIFO_RXUF, sport->port.membase + UARTSFIFO);
+	}
+
 	writeb(0, sport->port.membase + UARTTWFIFO);
 	writeb(1, sport->port.membase + UARTRWFIFO);
 
-- 
2.9.0