[PATCH v0 1/4] i2c: bcm-iproc: Use complete() instead of complete_all()

[Daniel Wagner]

From: Daniel Wagner <daniel.wagner@xxxxxxxxxxxx>

There is only one waiter for the completion, therefore there
is no need to use complete_all(). Let's make that clear by
using complete() instead of complete_all().

The usage pattern of the completion is:

bcm_iproc_i2c_xfer_single_msg()
  reinit_completion()
  ...
  (activate the transfer)
  ...
  wait_for_completion_timeout()

Signed-off-by: Daniel Wagner <daniel.wagner@xxxxxxxxxxxx>
---
 drivers/i2c/busses/i2c-bcm-iproc.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/i2c/busses/i2c-bcm-iproc.c b/drivers/i2c/busses/i2c-bcm-iproc.c
index 19c8438..95f7cac 100644
--- a/drivers/i2c/busses/i2c-bcm-iproc.c
+++ b/drivers/i2c/busses/i2c-bcm-iproc.c
@@ -158,7 +158,7 @@ static irqreturn_t bcm_iproc_i2c_isr(int irq, void *data)
 
 	if (status & BIT(IS_M_START_BUSY_SHIFT)) {
 		iproc_i2c->xfer_is_done = 1;
-		complete_all(&iproc_i2c->done);
+		complete(&iproc_i2c->done);
 	}
 
 	writel(status, iproc_i2c->base + IS_OFFSET);
-- 
2.7.4