Re: [RFC v0 7/8] Input: ims-pcu: use firmware_stat instead of completion

[Bjorn Andersson]

On Wed 03 Aug 08:55 PDT 2016, Luis R. Rodriguez wrote:

> On Wed, Aug 03, 2016 at 08:57:09AM +0200, Daniel Wagner wrote:
> > On 08/02/2016 09:41 AM, Luis R. Rodriguez wrote:
[..]
> > Not sure if I get you here correctly. Is the 'system configurable
> > deterministic file' is a knob which controlled by user space? Or it
> > this something you define at compile time?
> 
> I meant at compile time on the kernel. So CONFIG_READ_READY_SENTINEL
> or something like this, and it be a string, which if set then when
> the kernel read APIs are used, then a new API could be introduced
> that would *only* enable reading through once that sentinel has
> been detected by the kernel to allowed through reads. Doing this
> per mount / target filesystem is rather cumbersome given possible
> overlaps in mounts and also pivot_root() being possible, so instead
> targeting simply the fs/exec.c enum kernel_read_file_id would seem
> more efficient and clean but we would need a decided upon set of
> paths per enum kernel_read_file_id as base (or just one path per
> enum kernel_read_file_id). For number of paths I mean the number
> of target directories to look for the sentinel per enum kernel_read_file_id,
> so for instance for READING_FIRMWARE perhaps just deciding on /lib/firmware/
> would suffice, but if this supported multiple paths another option may be
> for the sentinel to also be looked for in /lib/firmware/updates/,
> /lib/firmware/" UTS_RELEASE -- etc. It would *stop* after finding one
> sentinel on any of these paths.
> 
> If a system has has CONFIG_READ_READY_SENTINEL it would mean an agreed upon
> system configuration has been decided so that at any point in time reads
> against READING_FIRMWARE using a new kernel_read_file_from_path_sentinel()
> (or something like it) would only allow the read to go through once
> the sentinel has been found for READING_FIRMWARE on the agreed upon
> paths.
> 
> The benefit of the sentintel approach is it avoids complexities with
> pivot_root(), and makes the deterministic aspect of the target left
> only to a system-configuration enabled target path / file.
> 

This sounds reasonable, it could be configured to wait for a certain
static file or userspace could generate this file once it reaches some
checkpoint.


Just to provide some additional input to "will rootfs mounted be enough
of a sentinel".

In an Android device you have a initramfs that will read an fstab file
and mount /system that holds most firmware, for some platforms
additional firmware will come from a third partition (in the Qualcomm
case mounted in /persist by the same mechanism).

With the sentinel approach one could configure the system either point
it at a file in the last file system to be mounted or have init generate
a file once its done with this; or in the generic configuration just
wait for /lib/firmware to show up.

I like this approach.

> This is just an idea. I'd like some FS folks to review.
> 

Regards,
Bjorn