Re: debug tip after earlycon is closed?

[Masahiro Yamada]

Hi.




2016-07-28 16:44 GMT+09:00 Arnd Bergmann <arnd@xxxxxxxx>:
>
> I think the problem is that you have three consoles:
>
> - the boot console that stays active until a real console comes up
> - the framebuffer console that is initialized early and goes on to
>   disable the bootconsole
> - the serial console that you are looking at but which doesn't get
>   initialized until much later
>
> Clearly something is wrong in this setup and we don't want to
> disable the boot console before the serial console is up.
>
> I guess you could work around it by disabling the framebuffer console
> at compile time, or by having the serial console initialized earlier
> than the framebuffer, but I wonder if this is something that could
> use a more general solution.


Looks like this comes from:

#elif defined(CONFIG_DUMMY_CONSOLE)
        conswitchp = &dummy_con;
#endif


console= in the kernel-parameter is no problem,
but stdout-path in the chose node goes wrong with it.






2016-07-28 21:20 GMT+09:00 Russell King - ARM Linux <linux@xxxxxxxxxxxxxxx>:
> I think this is down to how the linux,stdout property is handled.
>
> Normally, with command line specified consoles, if you don't specify
> anything, you get the framebuffer console (actually, it's the first
> registered console, but practically this is the framebuffer if enabled)
> by default.
>
> If you specify a console (or consoles) on the command line, you get
> all of those you specified, (iirc) with /dev/console's input connected
> to the first specified console.
>
> This happens because the command line is parsed for consoles, and
> add_preferred_console() is called for each that are found, whether or
> not drivers are discovered for them.  __add_preferred_console()
> prevents the first registered console being automatically initialised
> by setting selected_console to a non-negative number.
>
> However, the parsing of DT specified consoles occurs at driver
> initialisation time - in uart_add_one_port() via of_console_check().
> Only at this time is add_preferred_console() called, which means that
> the first console registered prior to _any_ selected UART console
> driver mentioned in DT will become active.
>
> When the first console becomes active, the earlycon is disabled, which
> means that in the DT case, if we have a framebuffer enabled which
> registers prior to any selected UART console, the framebuffer will
> stop the earlycon output immediately.
>
> To me, what this means is that the DT parsing of linux,stdout is
> broken - while it may look nice from a design point of view, the
> design is wrong and fails to take account of non-UART consoles in
> the system.


Thanks for clarification.
I agree that stdout-path is something wrong.



Since I switched
from

chosen {

         bootargs = "console=ttyS0,115200";
};

to

chosen {
        stdout-path = "serial0:115200n8";
};


I have had bad experiences.



The combination of stdout-path and earlycon gives doubled log.
I reported this in  https://lkml.org/lkml/2015/11/27/170
but not fixed yet.



I could fix the problem by changing


chosen {
         stdout-path = "serial0:115200n8";
         bootargs = "earlycon";
};

to

chosen {
         bootargs = "console=ttyS0,115200
earlycon=uniphier,mmio32,0x54006800,115200";
};






-- 
Best Regards
Masahiro Yamada