Re: [PATCH 1/2] ARM: dts: am57xx-beagle-x15: Remove pinmux configurations

[Nishanth Menon]

On 09/02/2016 05:18 AM, Sekhar Nori wrote:
> On Friday 02 September 2016 02:35 PM, Nishanth Menon wrote:
> > pinmuxing for DRA7x/AM57x family of processors need to be done in IO
> > isolation as part of initial bootloader executed from SRAM. This is
> > done as part of iodelay configuration sequence and is required due to
> > the limitations introduced by erratum ID: i869[1] and elaborated in
> > the Technical Reference Manual[2] 18.4.6.1.7 Isolation Requirements.
> >
> > Only peripheral that is permitted for dynamic pin mux configuration is
> > MMC. This is to accommodate the requirements for varied speeds (which
>
> Actually its MMC and DCAN. DCAN because of i893 ("DCAN Initialization
> Sequence"). But I can see you may have omitted reference to it since
> DCAN is not really used on the x15.

True, I should add that for completeness. will do. thanks for catching 
the same.


--
Regards,
Nishanth Menon