Re: [PATCH] gpio: mpc8xxx: Correct irq handler function

[Linus Walleij]

On Mon, Oct 24, 2016 at 5:46 AM, Gang Liu <gang.liu@xxxxxxx> wrote:
>> On Fri, Oct 21, 2016 at 9:31 AM, Liu Gang <Gang.Liu@xxxxxxx> wrote:
>>
>> > From the beginning of the gpio-mpc8xxx.c, the "handle_level_irq"
>> > has being used to handle GPIO interrupts in the PowerPC/Layerscape
>> > platforms. But actually, almost all PowerPC/Layerscape platforms
>> > assert an interrupt request upon either a high-to-low change or any
>> > change on the state of the signal.
>> >
>> > So the "handle_level_irq" is not reasonable for PowerPC/Layerscape
>> > GPIO interrupt, it should be "handle_edge_irq". Otherwise the system
>> > may lost some interrupts from the PIN's state changes.
>> >
>> > Signed-off-by: Liu Gang <Gang.Liu@xxxxxxx>
>>
>> Yes and especially so since this irqchip implements .irq_ack() and unless you
>> use the edge handler it will never be called.
>>
>> Patch applied for fixes, tell me if it also needs to go into stable.
>>
> [Liu Gang] yes, please also put it into stable. Thanks!

Ooops too late. Will tell Greg to pick this separately.

Yours,
Linus Walleij