[PATCH v2 5/5] fpga manager: cyclone-ps-spi: make delay variable

[Joshua Clayton]

The status pin may not show ready in the time described in the
Altetera manual. check the value several times before giving up
For the hardware I am working on, the status pin takes 250 us,
5 times as long as described by Altera.

Signed-off-by: Joshua Clayton <stillcompiling@xxxxxxxxx>
---
 drivers/fpga/cyclone-ps-spi.c | 13 ++++++++-----
 1 file changed, 8 insertions(+), 5 deletions(-)

diff --git a/drivers/fpga/cyclone-ps-spi.c b/drivers/fpga/cyclone-ps-spi.c
index 4b70d5c..c368223 100644
--- a/drivers/fpga/cyclone-ps-spi.c
+++ b/drivers/fpga/cyclone-ps-spi.c
@@ -20,6 +20,7 @@
 
 #define FPGA_RESET_TIME		50   /* time in usecs to trigger FPGA config */
-#define FPGA_MIN_DELAY		250  /* min usecs to wait for config status */
+#define FPGA_MIN_DELAY		50   /* min usecs to wait for config status */
+#define FPGA_MAX_DELAY		1000 /* max usecs to wait for config status */
 
 struct cyclonespi_conf {
 	struct gpio_desc *config;
@@ -42,6 +43,7 @@ static int cyclonespi_write_init(struct fpga_manager *mgr, u32 flags,
 				 const char *buf, size_t count)
 {
 	struct cyclonespi_conf *conf = (struct cyclonespi_conf *)mgr->priv;
+	int i;
 
 	if (flags & FPGA_MGR_PARTIAL_RECONFIG) {
 		dev_err(&mgr->dev, "Partial reconfiguration not supported.\n");
@@ -56,13 +58,14 @@ static int cyclonespi_write_init(struct fpga_manager *mgr, u32 flags,
 	}
 
 	gpiod_set_value(conf->config, 1);
-	usleep_range(FPGA_MIN_DELAY, FPGA_MIN_DELAY + 20);
-	if (gpiod_get_value(conf->status) == 0) {
-		dev_err(&mgr->dev, "Status pin not ready.\n");
-		return -EIO;
+	for (i = 0; i < (FPGA_MAX_DELAY / FPGA_MIN_DELAY); i++) {
+		usleep_range(FPGA_MIN_DELAY, FPGA_MIN_DELAY + 20);
+		if (gpiod_get_value(conf->status))
+			return 0;
 	}
 
-	return 0;
+	dev_err(&mgr->dev, "Status pin not ready.\n");
+	return -EIO;
 }
 
 static void rev_buf(void *buf, size_t len)
-- 
2.7.4