Re: [PATCH v3 0/6] add NS2 support to bgmac

From: Scott Branden
Date: Tue Nov 01 2016 - 14:01:35 EST

Hi Jon,

On 16-11-01 10:51 AM, Jon Mason wrote:
Changes in v3:
* Clean-up the bgmac DT binding doc (per Rob Herring)
* Document the lane swap binding and make it generic (Per Andrew Lunn)
Where is the documentation of the lane swap binding?

Changes in v2:
* Remove the PHY power-on (per Andrew Lunn)
* Misc PHY clean-ups regarding comments and #defines (per Andrew Lunn)
This results on none of the original PHY code from Vikas being
present. So, I'm removing him as an author and giving him
"Inspired-by" credit.
* Move PHY lane swapping to PHY driver (per Andrew Lunn and Florian
* Remove bgmac sleep (per Florian Fainelli)
* Re-add bgmac chip reset (per Florian Fainelli and Ray Jui)
* Rebased on latest net-next
* Added patch for bcm54xx_auxctl_read, which is used in the BCM54810

Add support for the amac found in the Broadcom Northstar2 SoC to the
bgmac driver. This necessitates adding support to connect to an
externally defined phy (as described in the device tree) in the driver.
These phy changes are in addition to the changes necessary to get NS2

Jon Mason (6):
net: phy: broadcom: add bcm54xx_auxctl_read
net: phy: broadcom: Add BCM54810 PHY entry
Documentation: devicetree: net: add NS2 bindings to amac
net: ethernet: bgmac: device tree phy enablement
net: ethernet: bgmac: add NS2 support
arm64: dts: NS2: add AMAC ethernet support

.../devicetree/bindings/net/brcm,amac.txt | 16 ++--
arch/arm64/boot/dts/broadcom/ns2-svk.dts | 5 ++
arch/arm64/boot/dts/broadcom/ns2.dtsi | 12 +++
drivers/net/ethernet/broadcom/bgmac-bcma.c | 48 ++++++++++
drivers/net/ethernet/broadcom/bgmac-platform.c | 100 ++++++++++++++++++++-
drivers/net/ethernet/broadcom/bgmac.c | 55 ++----------
drivers/net/ethernet/broadcom/bgmac.h | 8 ++
drivers/net/phy/Kconfig | 2 +-
drivers/net/phy/broadcom.c | 68 +++++++++++++-
include/linux/brcmphy.h | 11 +++
10 files changed, 268 insertions(+), 57 deletions(-)