Re: [PATCH v2 04/14] ASoC: sun4i-codec: Increase DMA max burst to 8

[Maxime Ripard]

On Thu, Nov 03, 2016 at 03:55:46PM +0800, Chen-Yu Tsai wrote:
> According to the DMA engine API documentation, maxburst denotes the
> largest possible size of a single transfer, so as not to overflow
> destination FIFOs as explained in this excerpt from dmaengine.h
> 
>  * @src_maxburst: the maximum number of words (note: words, as in
>  * units of the src_addr_width member, not bytes) that can be sent
>  * in one burst to the device. Typically something like half the
>  * FIFO depth on I/O peripherals so you don't overflow it. This
>  * may or may not be applicable on memory sources.
>  * @dst_maxburst: same as src_maxburst but for destination target
>  * mutatis mutandis.
> 
> The TX FIFO is 64 samples deep for stereo, and the RX FIFO is 16
> samples deep. So maxburst could be 32 and 8 for TX and RX respectively.
> 
> Unfortunately the sunxi DMA controller driver takes maxburst as
> the requested burst size, rather than a limit, and returns an error
> for unsupported values. The original value was 4, but some later
> SoCs do not officially support this burst size.
> 
> This patch increases maxburst on the TX side to 8, which is supported
> by all variants of the sunxi DMA controller.
> 
> Cc: Vinod Koul <vinod.koul@xxxxxxxxx>
> Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx>

Acked-by: Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx>

Thanks,
Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com

Attachment: signature.asc
Description: PGP signature