[PATCH v2 1/3] pinctrl: sunxi: Fix PIN_CONFIG_BIAS_PULL_{DOWN,UP} argument

From: Chen-Yu Tsai
Date: Thu Nov 10 2016 - 21:45:29 EST


According to pinconf-generic.h, the argument for
PIN_CONFIG_BIAS_PULL_{DOWN,UP} is non-zero if the bias is enabled
with a pull up/down resistor, zero if it is directly connected
to VDD or ground.

Since Allwinner hardware uses a weak pull resistor internally,
the argument should be 1.

Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx>
---
drivers/pinctrl/sunxi/pinctrl-sunxi.c | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/pinctrl/sunxi/pinctrl-sunxi.c b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
index e199d95af8c0..e04edda8629d 100644
--- a/drivers/pinctrl/sunxi/pinctrl-sunxi.c
+++ b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
@@ -291,12 +291,16 @@ static unsigned long *sunxi_pctrl_build_pin_config(struct device_node *node,

if (sunxi_pctrl_has_bias_prop(node)) {
int pull = sunxi_pctrl_parse_bias_prop(node);
+ int arg = 0;
if (pull < 0) {
ret = pull;
goto err_free;
}

- pinconfig[idx++] = pinconf_to_config_packed(pull, 0);
+ if (pull != PIN_CONFIG_BIAS_DISABLE)
+ arg = 1; /* hardware uses weak pull resistors */
+
+ pinconfig[idx++] = pinconf_to_config_packed(pull, arg);
}


--
2.10.2