Re: [PATCH 2/2] dmaengine: omap-dma: Support for slave devices with data port window

[Vinod Koul]

On Tue, Oct 25, 2016 at 01:50:19PM +0300, Peter Ujfalusi wrote:
> Based on the src/dst_port_window_size - if it is set - configure the DMA
> channel to use double indexing in order to be able to loop within the
> address window.
> 
> Signed-off-by: Peter Ujfalusi <peter.ujfalusi@xxxxxx>
> ---
>  drivers/dma/omap-dma.c | 45 +++++++++++++++++++++++++++++++++++++++++++--
>  1 file changed, 43 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/dma/omap-dma.c b/drivers/dma/omap-dma.c
> index 025f499cb20d..29350f936154 100644
> --- a/drivers/dma/omap-dma.c
> +++ b/drivers/dma/omap-dma.c
> @@ -166,6 +166,9 @@ enum {
>  	CSDP_DST_BURST_16	= 1 << 14,
>  	CSDP_DST_BURST_32	= 2 << 14,
>  	CSDP_DST_BURST_64	= 3 << 14,
> +	CSDP_WRITE_NON_POSTED	= (0 << 16),

and that would be..?

> +	CSDP_WRITE_POSTED	= (1 << 16),
> +	CSDP_WRITE_LAST_NON_POSTED = (2 << 16),
>  
>  	CICR_TOUT_IE		= BIT(0),	/* OMAP1 only */
>  	CICR_DROP_IE		= BIT(1),
> @@ -883,15 +886,18 @@ static struct dma_async_tx_descriptor *omap_dma_prep_slave_sg(
>  	unsigned i, es, en, frame_bytes;
>  	bool ll_failed = false;
>  	u32 burst;
> +	int32_t port_window;

not u32?

>  
>  	if (dir == DMA_DEV_TO_MEM) {
>  		dev_addr = c->cfg.src_addr;
>  		dev_width = c->cfg.src_addr_width;
>  		burst = c->cfg.src_maxburst;
> +		port_window = c->cfg.src_port_window_size;
>  	} else if (dir == DMA_MEM_TO_DEV) {
>  		dev_addr = c->cfg.dst_addr;
>  		dev_width = c->cfg.dst_addr_width;
>  		burst = c->cfg.dst_maxburst;
> +		port_window = c->cfg.dst_port_window_size;
>  	} else {
>  		dev_err(chan->device->dev, "%s: bad direction?\n", __func__);
>  		return NULL;
> @@ -923,11 +929,39 @@ static struct dma_async_tx_descriptor *omap_dma_prep_slave_sg(
>  
>  	d->ccr = c->ccr | CCR_SYNC_FRAME;
>  	if (dir == DMA_DEV_TO_MEM) {
> -		d->ccr |= CCR_DST_AMODE_POSTINC | CCR_SRC_AMODE_CONSTANT;
>  		d->csdp = CSDP_DST_BURST_64 | CSDP_DST_PACKED;
> +
> +		d->ccr |= CCR_DST_AMODE_POSTINC;
> +		if (port_window) {
> +			d->ccr |= CCR_SRC_AMODE_DBLIDX;
> +			d->ei = 1;
> +			d->fi = (-1) * (port_window - 1);
> +
> +			if (port_window / 64)
> +				d->csdp = CSDP_SRC_BURST_64 | CSDP_SRC_PACKED;
> +			else if (port_window / 32)
> +				d->csdp = CSDP_SRC_BURST_32 | CSDP_SRC_PACKED;
> +			else if (port_window / 16)
> +				d->csdp = CSDP_SRC_BURST_16 | CSDP_SRC_PACKED;
> +		} else {
> +			d->ccr |= CCR_SRC_AMODE_CONSTANT;

okay does all your hw support this mode, should this not be checked to be
supported, perhpas a DT property which describes thsi capablity and then you
use it, if supported

> +		}
>  	} else {
> -		d->ccr |= CCR_DST_AMODE_CONSTANT | CCR_SRC_AMODE_POSTINC;
>  		d->csdp = CSDP_SRC_BURST_64 | CSDP_SRC_PACKED;
> +
> +		d->ccr |= CCR_SRC_AMODE_POSTINC;
> +		if (port_window) {
> +			d->ccr |= CCR_DST_AMODE_DBLIDX;
> +
> +			if (port_window / 64)
> +				d->csdp = CSDP_DST_BURST_64 | CSDP_DST_PACKED;
> +			else if (port_window / 32)
> +				d->csdp = CSDP_DST_BURST_32 | CSDP_DST_PACKED;
> +			else if (port_window / 16)
> +				d->csdp = CSDP_DST_BURST_16 | CSDP_DST_PACKED;

what does these mean?

> +		} else {
> +			d->ccr |= CCR_DST_AMODE_CONSTANT;
> +		}
>  	}
>  
>  	d->cicr = CICR_DROP_IE | CICR_BLOCK_IE;
> @@ -945,6 +979,9 @@ static struct dma_async_tx_descriptor *omap_dma_prep_slave_sg(
>  			d->ccr |= CCR_TRIGGER_SRC;
>  
>  		d->cicr |= CICR_MISALIGNED_ERR_IE | CICR_TRANS_ERR_IE;
> +
> +		if (port_window)
> +			d->csdp |= CSDP_WRITE_LAST_NON_POSTED;
>  	}
>  	if (od->plat->errata & DMA_ERRATA_PARALLEL_CHANNELS)
>  		d->clnk_ctrl = c->dma_ch;
> @@ -970,6 +1007,10 @@ static struct dma_async_tx_descriptor *omap_dma_prep_slave_sg(
>  		osg->addr = sg_dma_address(sgent);
>  		osg->en = en;
>  		osg->fn = sg_dma_len(sgent) / frame_bytes;
> +		if (port_window && dir == DMA_MEM_TO_DEV) {
> +			osg->ei = 1;
> +			osg->fi = (-1) * (port_window - 1);
> +		}

can you describe what you are trying here..

-- 
~Vinod