Re: [PATCH v2] fsl/usb: Workarourd for USB erratum-A005697

[Sergei Shtylyov]

Hello.

On 11/25/2016 06:24 AM, Changming Huang wrote:

> The EHCI specification states the following in the SUSP bit description:
> In the Suspend state, the port is senstive to resume detection.

   Sensitive.

> Note that the bit status does not change untile the port is suspended and

   Until.

> that there may be a delay in susupending a port if there is a transaction

   Suspending.

> currently in progress on the USB.
>
> However, in NXP USBDR controller, the PORTSCx[SUSP] bit changes immediately
> when the application sets it and not when the port is actually suspended.
>
> So the application must wait for at least 10 milliseconds after a port
> indicates that it is suspended, to make sure this port has entered
> suspended state before initiating this port resume using the Force Port
> Resume bit. This bit is for NXP controller, not EHCI compatible.
>
> Signed-off-by: Changming Huang <jerry.huang@xxxxxxx>
> Signed-off-by: Ramneek Mehresh <ramneek.mehresh@xxxxxxx>

[...]

> diff --git a/drivers/usb/host/ehci-hub.c b/drivers/usb/host/ehci-hub.c
> index 74f62d6..81e2310 100644
> --- a/drivers/usb/host/ehci-hub.c
> +++ b/drivers/usb/host/ehci-hub.c
> @@ -310,6 +310,13 @@ static int ehci_bus_suspend (struct usb_hcd *hcd)
>  	}
>  	spin_unlock_irq(&ehci->lock);
>
> +	if (changed && ehci_has_fsl_susp_errata(ehci))
> +		/* Wait for at least 10 millisecondes to ensure the controller

   Milliseconds.

> +		 * enter the suspend status before initiating a port resume
> +		 * using the Fore Port Resume bit (Not-EHCI compatible).

   Maybe force?
   s/Not/non/ also.

> +		 */
> +		usleep_range(10000, 20000);
> +
>  	if ((changed && ehci->has_tdi_phy_lpm) || fs_idle_delay) {
>  		/*
>  		 * Wait for HCD to enter low-power mode or for the bus
[...]
> @@ -703,10 +704,15 @@ struct ehci_tt {
>  #if defined(CONFIG_PPC_85xx)
>  /* Some Freescale processors have an erratum (USB A-005275) in which
>   * incoming packets get corrupted in HS mode
> + * Some Freescale processors have an erratum (USB A-005697) in which
> + * we need to wait for 10ms for bus to fo into suspend mode after

   Fo?

[...]

MBR, Sergei