[PATCH 11/11] ARM: bcm2835: Enable the Raspberry Pi touchscreen panel.
From: Eric Anholt
Date: Wed Dec 14 2016 - 14:48:33 EST
This commit is not intended to be merged. Instead we will use
overlays to enable the panel, and this commit is just a demo of how
things get wired up.
Signed-off-by: Eric Anholt <eric@xxxxxxxxxx>
---
arch/arm/boot/dts/bcm283x.dtsi | 30 +++++++++++++++++++++++++++++-
1 file changed, 29 insertions(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/bcm283x.dtsi b/arch/arm/boot/dts/bcm283x.dtsi
index 82a4eccfb3d8..e96d0f29759a 100644
--- a/arch/arm/boot/dts/bcm283x.dtsi
+++ b/arch/arm/boot/dts/bcm283x.dtsi
@@ -286,7 +286,12 @@
"dsi1_ddr2",
"dsi1_ddr";
- status = "disabled";
+ pitouchscreen: panel@0 {
+ compatible = "raspberrypi,touchscreen";
+ reg = <0>;
+
+ raspberrypi,touchscreen-bridge = <&pitouchscreen_bridge>;
+ };
};
i2c1: i2c@7e804000 {
@@ -346,6 +351,29 @@
vc4: gpu {
compatible = "brcm,bcm2835-vc4";
};
+
+ i2c_dsi: i2c {
+ /* We have to use i2c-gpio because the
+ * firmware is also polling another device
+ * using the only hardware I2C bus that could
+ * connect to these pins.
+ */
+ compatible = "i2c-gpio";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ gpios = <&gpio 28 0
+ &gpio 29 0>;
+
+ pitouchscreen_bridge: bridge@45 {
+ compatible = "raspberrypi,touchscreen-bridge-i2c";
+ reg = <0x45>;
+ };
+
+ pitouchscreen_touch: bridge@38 {
+ compatible = "raspberrypi,touchscreen-ts-i2c";
+ reg = <0x38>;
+ };
+ };
};
clocks {
--
2.11.0