Re: [PATCH 5/8] extcon: axp288: Make a couple of messages dev_info instead of dev_dbg

[Chanwoo Choi]

Hi Hans,

I prefer to use the dev_dbg on the fly instead of dev_info.
If you want to check the change state, you can use the udev monitor tool
because extcon send the uevent when changing the state of connector.

Regards,
Chanwoo Choi

On 2016ë 12ì 19ì 09:13, Hans de Goede wrote:
> These messages are helpful for the user to check if their charger is
> correctly detected, so make them dev_dbg instead of dev_info.
> 
> Also add a new message to indicate when the vbus is disconnected /
> no cable is detected.
> 
> Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
> ---
>  drivers/extcon/extcon-axp288.c | 10 ++++++----
>  1 file changed, 6 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/extcon/extcon-axp288.c b/drivers/extcon/extcon-axp288.c
> index ded0bd9..fc636f6 100644
> --- a/drivers/extcon/extcon-axp288.c
> +++ b/drivers/extcon/extcon-axp288.c
> @@ -167,8 +167,10 @@ static int axp288_handle_chrg_det_event(struct axp288_extcon_info *info)
>  	}
>  
>  	vbus_attach = (pwr_stat & PS_STAT_VBUS_PRESENT);
> -	if (!vbus_attach)
> +	if (!vbus_attach) {
> +		dev_info(info->dev, "vbus/cable disconnected\n");
>  		goto no_vbus;
> +	}
>  
>  	/* Check charger detection completion status */
>  	ret = regmap_read(info->regmap, AXP288_BC_GLOBAL_REG, &cfg);
> @@ -187,15 +189,15 @@ static int axp288_handle_chrg_det_event(struct axp288_extcon_info *info)
>  
>  	switch (chrg_type) {
>  	case DET_STAT_SDP:
> -		dev_dbg(info->dev, "sdp cable is connected\n");
> +		dev_info(info->dev, "sdp cable is connected\n");
>  		cable = EXTCON_CHG_USB_SDP;
>  		break;
>  	case DET_STAT_CDP:
> -		dev_dbg(info->dev, "cdp cable is connected\n");
> +		dev_info(info->dev, "cdp cable is connected\n");
>  		cable = EXTCON_CHG_USB_CDP;
>  		break;
>  	case DET_STAT_DCP:
> -		dev_dbg(info->dev, "dcp cable is connected\n");
> +		dev_info(info->dev, "dcp cable is connected\n");
>  		cable = EXTCON_CHG_USB_DCP;
>  		break;
>  	default:
>