Re: [PATCH 0/2] Begin auditing SECCOMP_RET_ERRNO return actions

[Andy Lutomirski]

On Mon, Jan 2, 2017 at 2:47 PM, Paul Moore <paul@xxxxxxxxxxxxxx> wrote:
> On Mon, Jan 2, 2017 at 11:53 AM, Tyler Hicks <tyhicks@xxxxxxxxxxxxx> wrote:
>> This patch set creates the basis for auditing information specific to a given
>> seccomp return action and then starts auditing SECCOMP_RET_ERRNO return
>> actions. The audit messages for SECCOMP_RET_ERRNO return actions include the
>> errno value that will be returned to userspace.
>
> I'm replying to this patchset posting because it his my inbox first,
> but my comments here apply to both this patchset and the other
> seccomp/audit patchset you posted.
>
> In my experience, we have two or three problems (the count varies
> depending on perspective) when it comes to seccomp filter reporting:
>
> 1. Inability to log all filter actions.
> 2. Inability to selectively enable filtering; e.g. devs want noisy
> logging, users want relative quiet.
> 3. Consistent behavior with audit enabled and disabled.
>
> My current thinking - forgive me, this has been kicking around in my
> head for the better part of six months (longer?) and I haven't
> attempted to code it up - is to create a sysctl knob for a system wide
> seccomp logging threshold that would be applied to the high 16-bits of
> *every* triggered action: if the action was at/below the threshold a
> record would be emitted, otherwise silence.  This should resolve
> problems #1 and #2, and the code should be relatively straightforward
> and small.
>
> As part of the code above, I expect that all seccomp logging would get
> routed through a single logging function (sort of like a better
> implementation of the existing audit_seccomp()) that would check the
> threshold and trigger the logging if needed.  This function could be
> augmented to check for CONFIG_AUDIT and in the case where audit was
> not built into the kernel, a simple printk could be used to log the
> seccomp event; solving problem #3.

Would this not be doable with a seccomp tracepoint and a BPF filter?

--Andy