Re: [PATCH v5 3/3] arm64: dts: exynos: Add support for S6E3HA2 panel device on TM2 board

[Andrzej Hajda]

On 04.01.2017 09:15, Hoegeun Kwon wrote:
> From: Hyungwon Hwang <human.hwang@xxxxxxxxxxx>
>
> This patch add the panel device tree node for S6E3HA2 display
> controller to TM2 dts.
>
> Signed-off-by: Hyungwon Hwang <human.hwang@xxxxxxxxxxx>
> Signed-off-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx>
> Signed-off-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx>
> Signed-off-by: Hoegeun Kwon <hoegeun.kwon@xxxxxxxxxxx>

Reviewed-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx>
--
Regards
Andrzej

> ---
>  arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 17 +++++++++++++++++
>  1 file changed, 17 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> index 5b9451d..b3ba1ac 100644
> --- a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> +++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> @@ -304,11 +304,28 @@
>  			reg = <1>;
>  
>  			dsi_out: endpoint {
> +				remote-endpoint = <&panel_in>;
>  				samsung,burst-clock-frequency = <512000000>;
>  				samsung,esc-clock-frequency = <16000000>;
>  			};
>  		};
>  	};
> +
> +	panel@0 {
> +		compatible = "samsung,s6e3ha2";
> +		reg = <0>;
> +		vdd3-supply = <&ldo27_reg>;
> +		vci-supply = <&ldo28_reg>;
> +		reset-gpios = <&gpg0 0 GPIO_ACTIVE_LOW>;
> +		enable-gpios = <&gpf1 5 GPIO_ACTIVE_HIGH>;
> +		te-gpios = <&gpf1 3 GPIO_ACTIVE_HIGH>;
> +
> +		port {
> +			panel_in: endpoint {
> +				remote-endpoint = <&dsi_out>;
> +			};
> +		};
> +	};
>  };
>  
>  &hsi2c_0 {