[PATCH v2] drm: Schedule the output_poll_work with 1s delay if we have delayed event
From: Peter Ujfalusi
Date: Mon Jan 09 2017 - 09:34:02 EST
Instead of scheduling the work to handle the initial delayed event, use 1s
delay.
This delay should not be needed, but Optimus/nouveau will fail in a
mysterious way if the delayed event is handled as soon as possible like it
is done in drm_helper_probe_single_connector_modes() in case the poll
was enabled before.
Reverting 339fd36238dd would give back the 10 sec (!) delay to handle the
delayed event. Adding 1sec delay to the poll_work is enough to work around
the issue in Optimus setups and gives shorter response on handling the
initial delayed event.
Fixes: 339fd36238dd ("drm: drm_probe_helper: Fix output_poll_work scheduling")
Cc: stable@xxxxxxxxxxxxxxx # v4.9
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@xxxxxx>
---
drivers/gpu/drm/drm_probe_helper.c | 10 +++++++++-
1 file changed, 9 insertions(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/drm_probe_helper.c b/drivers/gpu/drm/drm_probe_helper.c
index 06a62e37fbdc..258abed43e38 100644
--- a/drivers/gpu/drm/drm_probe_helper.c
+++ b/drivers/gpu/drm/drm_probe_helper.c
@@ -146,8 +146,16 @@ void drm_kms_helper_poll_enable_locked(struct drm_device *dev)
drm_connector_list_iter_put(&conn_iter);
if (dev->mode_config.delayed_event) {
+ /*
+ * Use short (1s) delay to handle the initial delayed event.
+ * This delay should not be needed, but Optimus/nouveau will
+ * fail in a mysterious way if the delayed event is handled as
+ * soon as possible like it is done in
+ * drm_helper_probe_single_connector_modes() in case the poll
+ * was enabled before.
+ */
poll = true;
- delay = 0;
+ delay = HZ;
}
if (poll)
--
2.11.0