Re: [PATCH 2/2] ARM: dts: rockchip: add dts for RK3288-Tinker board

[Heiko Stuebner]

Hi Eddie,

Am Donnerstag, 19. Januar 2017, 10:11:59 CET schrieb Eddie Cai:
> This patch add basic support for RK3288-Tinker board. We can boot in to
> rootfs with this patch.
> 
> Signed-off-by: Eddie Cai <eddie.cai@xxxxxxxxxxxxxx>

looks good in general, just some small question down below.

[...]

> +	/*
> +	 * NOTE: vcc_sd isn't hooked up on v1.0 boards where power comes from
> +	 * vcc_io directly.  Those boards won't be able to power cycle SD cards
> +	 * but it shouldn't hurt to toggle this pin there anyway.
> +	 */

just to clarify, later board will have that pin connected, right?

> +	vcc_sd: sdmmc-regulator {
> +		compatible = "regulator-fixed";
> +		gpio = <&gpio7 11 GPIO_ACTIVE_LOW>;
> +		pinctrl-names = "default";
> +		pinctrl-0 = <&sdmmc_pwr>;
> +		regulator-name = "vcc_sd";
> +		regulator-min-microvolt = <3300000>;
> +		regulator-max-microvolt = <3300000>;
> +		startup-delay-us = <100000>;
> +		vin-supply = <&vcc_io>;
> +	};
> +};

[...]

> +&hdmi {
> +	#address-cells = <1>;
> +	#size-cells = <0>;
> +	#sound-dai-cells = <0>;
> +	ddc-i2c-bus = <&i2c5>;
> +	status = "okay";
> +	/* Don't use vopl for HDMI */
> +	ports {
> +		hdmi_in: port {
> +			/delete-node/ endpoint@1;
> +		};

what is the reason for this? You enable both VOPs below and the linux display 
subsystem should be able to select an appropriate VOP for output just fine on 
its own. So there should be no reason for capping the hdmi's connection to one 
of the vops.

> +	};
> +};

[...]

> +&usb_host0_ehci {
> +	no-relinquish-port;

This seems like an unused/undocumented property

> +	status = "okay";
> +};

[...]

> +&vopl {
> +	status = "okay";
> +	/* Don't use vopl for HDMI */
> +	vopl_out: port {
> +		/delete-node/ endpoint@0;
> +	};

see comment at the hdmi node

> +};


Thanks
Heiko