[PATCH 15/15] Staging: rtl8192u: ieee80211: ieee80211.h - style fix

From: Derek Robson
Date: Thu Feb 16 2017 - 00:34:43 EST

Fixed style of block comments
Found using checkpatch

Signed-off-by: Derek Robson <robsonde@xxxxxxxxx>
---
drivers/staging/rtl8192u/ieee80211/ieee80211.h | 61 +++++++++++++++-----------
1 file changed, 36 insertions(+), 25 deletions(-)

diff --git a/drivers/staging/rtl8192u/ieee80211/ieee80211.h b/drivers/staging/rtl8192u/ieee80211/ieee80211.h
index 1bba5170e25a..0d247058bce4 100644
--- a/drivers/staging/rtl8192u/ieee80211/ieee80211.h
+++ b/drivers/staging/rtl8192u/ieee80211/ieee80211.h
@@ -329,12 +329,13 @@ typedef struct ieee_param {
// linux under 2.6.9 release may not support it, so modify it for common use
#define IEEE80211_DATA_LEN 2304
/* Maximum size for the MA-UNITDATA primitive, 802.11 standard section
- 6.2.1.1.2.
-
- The figure in section 7.1.2 suggests a body size of up to 2312
- bytes is allowed, which is a bit confusing, I suspect this
- represents the 2304 bytes of real data, plus a possible 8 bytes of
- WEP IV and ICV. (this interpretation suggested by Ramiro Barreiro) */
+ * 6.2.1.1.2.
+ *
+ * The figure in section 7.1.2 suggests a body size of up to 2312
+ * bytes is allowed, which is a bit confusing, I suspect this
+ * represents the 2304 bytes of real data, plus a possible 8 bytes of
+ * WEP IV and ICV. (this interpretation suggested by Ramiro Barreiro)
+ */
#define IEEE80211_1ADDR_LEN 10
#define IEEE80211_2ADDR_LEN 16
#define IEEE80211_3ADDR_LEN 24
@@ -685,7 +686,8 @@ struct ieee_ibss_seq {

/* NOTE: This data is for statistical purposes; not all hardware provides this
* information for frames received. Not setting these will not cause
- * any adverse affects. */
+ * any adverse affects.
+ */
struct ieee80211_rx_stats {
u32 mac_time[2];
s8 rssi;
@@ -754,7 +756,8 @@ struct ieee80211_rx_stats {
/* IEEE 802.11 requires that STA supports concurrent reception of at least
* three fragmented frames. This define can be increased to support more
* concurrent frames, but it should be noted that each entry can consume about
- * 2 kB of RAM and increasing cache size will slow down frame reassembly. */
+ * 2 kB of RAM and increasing cache size will slow down frame reassembly.
+ */
#define IEEE80211_FRAG_CACHE_LEN 4

struct ieee80211_frag_entry {
@@ -836,15 +839,15 @@ struct ieee80211_security {


/*
- 802.11 data frame from AP
- ,-------------------------------------------------------------------.
-Bytes | 2 | 2 | 6 | 6 | 6 | 2 | 0..2312 | 4 |
- |------|------|---------|---------|---------|------|---------|------|
-Desc. | ctrl | dura | DA/RA | TA | SA | Sequ | frame | fcs |
- | | tion | (BSSID) | | | ence | data | |
- `-------------------------------------------------------------------'
-Total: 28-2340 bytes
-*/
+ * 802.11 data frame from AP
+ * ,-------------------------------------------------------------------.
+ * Bytes | 2 | 2 | 6 | 6 | 6 | 2 | 0..2312 | 4 |
+ * |------|------|---------|---------|---------|------|---------|------|
+ * Desc. | ctrl | dura | DA/RA | TA | SA | Sequ | frame | fcs |
+ * | | tion | (BSSID) | | | ence | data | |
+ * `-------------------------------------------------------------------'
+ * Total: 28-2340 bytes
+ */

/* Management Frame Information Element Types */
enum ieee80211_mfie {
@@ -882,7 +885,8 @@ enum ieee80211_mfie {

/* Minimal header; can be used for passing 802.11 frames with sufficient
* information to determine what type of underlying data type is actually
- * stored in the data. */
+ * stored in the data.
+ */
struct rtl_80211_hdr {
__le16 frame_ctl;
__le16 duration_id;
@@ -980,7 +984,8 @@ struct ieee80211_probe_response {
__le16 beacon_interval;
__le16 capability;
/* SSID, supported rates, FH params, DS params,
- * CF params, IBSS params, TIM (if beacon), RSN */
+ * CF params, IBSS params, TIM (if beacon), RSN
+ */
struct ieee80211_info_element info_element[0];
} __packed;

@@ -1055,7 +1060,8 @@ typedef union _frameqos {
/* MAX_RATES_LENGTH needs to be 12. The spec says 8, and many APs
* only use 8, and then use extended rates for the remaining supported
* rates. Other APs, however, stick all of their supported rates on the
- * main rates information element... */
+ * main rates information element...
+ */
#define MAX_RATES_LENGTH ((u8)12)
#define MAX_RATES_EX_LENGTH ((u8)16)
#define MAX_NETWORK_COUNT 128
@@ -1677,14 +1683,16 @@ struct ieee80211_device {
spinlock_t wpax_suitlist_lock;

int tx_headroom; /* Set to size of any additional room needed at front
- * of allocated Tx SKBs */
+ * of allocated Tx SKBs
+ */
u32 config;

/* WEP and other encryption related settings at the device level */
int open_wep; /* Set to 1 to allow unencrypted frames */
int auth_mode;
int reset_on_keychange; /* Set to 1 if the HW needs to be reset on
- * WEP key changes */
+ * WEP key changes
+ */

/* If the host performs {en,de}cryption, then set to 1 */
int host_encrypt;
@@ -1719,7 +1727,8 @@ struct ieee80211_device {
int crypt_quiesced;

int bcrx_sta_key; /* use individual keys to override default keys even
- * with RX of broad/multicast frames */
+ * with RX of broad/multicast frames
+ */

/* Fragmentation structures */
// each streaming contain a entry
@@ -2004,7 +2013,8 @@ struct ieee80211_device {
void (*InitialGainHandler)(struct net_device *dev, u8 Operation);

/* This must be the last item so that it points to the data
- * allocated beyond this structure by alloc_ieee80211 */
+ * allocated beyond this structure by alloc_ieee80211
+ */
u8 priv[0];
};

@@ -2033,7 +2043,8 @@ struct ieee80211_device {

/* The ieee802.11 stack will manages the netif queue
* wake/stop for the driver, taking care of 802.11
- * fragmentation. See softmac.c for details. */
+ * fragmentation. See softmac.c for details.
+ */
#define IEEE_SOFTMAC_TX_QUEUE (1<<7)

/* Uses only the softmac_data_hard_start_xmit
--
2.11.1