Re: [PATCH V2] PCI/ASPM: reconfigure ASPM following hotplug for POLICY_DEFAULT
From: Sinan Kaya
Date: Tue Feb 28 2017 - 10:14:59 EST
On 2/28/2017 6:03 AM, Patel, Mayurkumar wrote:
>> - /* Save default state */
>> - link->aspm_default = link->aspm_enabled;
> But, I am finding a problem with this change, if Policy is set to default,
> BIOS enables ASPM L1, but pcie_config_aspm_link() disables ASPM L1
> due to link->aspm_enabled is different than link->aspm_default while
> called from pcie_aspm_init_link_state() during hotplug insertion.
>
Thanks for testing. I think it means the enable count logic I put below
is not working.
I was trying to figure out when to use saved values vs. the values in
registers by looking at the enable_cnt.
enable_cnt is 0 during boot on my system.
The enable_cnt should have been non-zero following an insertion following
remove and default and enabled values should have been identical.
Can you print out the values of pdev->aspm_default, link->aspm_default,
and link->aspm_enabled in this function along with atomic_read(&pdev->enable_cnt)?
>
>> + /*
>> + * Save default state from FW when enabling ASPM for the first time
>> + * during boot by looking at the calculated link->aspm_enabled bits
>> + * above and enable_cnt will be zero.
>> + *
>> + * If this path is getting called for the second/third time
>> + * (enable_cnt will be non-zero). Assume that the current state of the
>> + * ASPM registers may not necessarily match what FW asked us to do as
>> + * in the case of hotplug insertion/removal.
>> + */
>> + if (!atomic_read(&pdev->enable_cnt))
>> + pdev->aspm_default = link->aspm_default = link->aspm_enabled;
>> + else
>> + link->aspm_default = pdev->aspm_default;
--
Sinan Kaya
Qualcomm Datacenter Technologies, Inc. as an affiliate of Qualcomm Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project.