Re: [PATCHv2] omap3isp: add support for CSI1 bus
From: Sakari Ailus
Date: Sat Mar 04 2017 - 10:40:31 EST
On Sat, Mar 04, 2017 at 03:03:18PM +0200, Sakari Ailus wrote:
> Hi Pavel,
>
> On Thu, Mar 02, 2017 at 01:38:48PM +0100, Pavel Machek wrote:
> > Hi!
> >
> > > > Ok, how about this one?
> > > > omap3isp: add rest of CSI1 support
> > > >
> > > > CSI1 needs one more bit to be set up. Do just that.
> > > >
> > > > It is not as straightforward as I'd like, see the comments in the code
> > > > for explanation.
> > ...
> > > > + if (isp->phy_type == ISP_PHY_TYPE_3430) {
> > > > + struct media_pad *pad;
> > > > + struct v4l2_subdev *sensor;
> > > > + const struct isp_ccp2_cfg *buscfg;
> > > > +
> > > > + pad = media_entity_remote_pad(&ccp2->pads[CCP2_PAD_SINK]);
> > > > + sensor = media_entity_to_v4l2_subdev(pad->entity);
> > > > + /* Struct isp_bus_cfg has union inside */
> > > > + buscfg = &((struct isp_bus_cfg *)sensor->host_priv)->bus.ccp2;
> > > > +
> > > > + csiphy_routing_cfg_3430(&isp->isp_csiphy2,
> > > > + ISP_INTERFACE_CCP2B_PHY1,
> > > > + enable, !!buscfg->phy_layer,
> > > > + buscfg->strobe_clk_pol);
> > >
> > > You should do this through omap3isp_csiphy_acquire(), and not call
> > > csiphy_routing_cfg_3430() directly from here.
> >
> > Well, unfortunately omap3isp_csiphy_acquire() does have csi2
> > assumptions hard-coded :-(.
> >
> > This will probably fail.
> >
> > rval = omap3isp_csi2_reset(phy->csi2);
> > if (rval < 0)
> > goto done;
>
> Could you try to two patches I've applied on the ccp2 branch (I'll remove
> them if there are issues).
>
> That's compile tested for now only.
One more thing. What's needed for configuring the PHY for CCP2?
For instance, is the CSI-2 PHY regulator still needed in
omap3isp_csiphy_acquire()? One way to do this might go to see the original
driver for N900; I don't have the TRM at hand right now.
--
Kind regards,
Sakari Ailus
e-mail: sakari.ailus@xxxxxx XMPP: sailus@xxxxxxxxxxxxxx