[PATCH 6/7] x86/xen/gdt: Use X86_FEATURE_XENPV instead of globals for the GDT fixup

[Andy Lutomirski]

Xen imposes special requirements on the GDT.  Rather than using a
global variable for the pgprot, just use an explicit special case
for Xen -- this makes it clearer what's going on.  It also debloats
64-bit kernels very slightly.

Cc: Boris Ostrovsky <boris.ostrovsky@xxxxxxxxxx>
Cc: Juergen Gross <jgross@xxxxxxxx>
Signed-off-by: Andy Lutomirski <luto@xxxxxxxxxx>
---
 arch/x86/include/asm/desc.h  |  1 -
 arch/x86/kernel/cpu/common.c | 28 +++++++++++++++++-----------
 arch/x86/xen/enlighten.c     |  3 ---
 3 files changed, 17 insertions(+), 15 deletions(-)

diff --git a/arch/x86/include/asm/desc.h b/arch/x86/include/asm/desc.h
index 17cb46e8a184..d0a21b12dd58 100644
--- a/arch/x86/include/asm/desc.h
+++ b/arch/x86/include/asm/desc.h
@@ -39,7 +39,6 @@ extern struct desc_ptr idt_descr;
 extern gate_desc idt_table[];
 extern const struct desc_ptr debug_idt_descr;
 extern gate_desc debug_idt_table[];
-extern pgprot_t pg_fixmap_gdt_flags;
 
 struct gdt_page {
 	struct desc_struct gdt[GDT_ENTRIES];
diff --git a/arch/x86/kernel/cpu/common.c b/arch/x86/kernel/cpu/common.c
index f6e20e2dbfa5..8ee32119144d 100644
--- a/arch/x86/kernel/cpu/common.c
+++ b/arch/x86/kernel/cpu/common.c
@@ -448,21 +448,27 @@ void load_percpu_segment(int cpu)
 	load_stack_canary_segment();
 }
 
-/*
- * On 64-bit the GDT remapping is read-only.
- * A global is used for Xen to change the default when required.
- */
+/* Setup the fixmap mapping only once per-processor */
+static inline void setup_fixmap_gdt(int cpu)
+{
 #ifdef CONFIG_X86_64
-pgprot_t pg_fixmap_gdt_flags = PAGE_KERNEL_RO;
+	/* On 64-bit systems, we use a read-only fixmap GDT. */
+	pgprot_t prot = PAGE_KERNEL_RO;
 #else
-pgprot_t pg_fixmap_gdt_flags = PAGE_KERNEL;
+	/*
+	 * On native 32-bit systems, the GDT cannot be read-only because
+	 * our double fault handler uses a task gate, and entering through
+	 * a task gate needs to change an available TSS to busy.  If the GDT
+	 * is read-only, that will triple fault.
+	 *
+	 * On Xen PV, the GDT must be read-only because the hypervisor requires
+	 * it.
+	 */
+	pgprot_t prot = boot_cpu_has(X86_FEATURE_XENPV) ?
+		PAGE_KERNEL_RO : PAGE_KERNEL;
 #endif
 
-/* Setup the fixmap mapping only once per-processor */
-static inline void setup_fixmap_gdt(int cpu)
-{
-	__set_fixmap(get_cpu_gdt_ro_index(cpu), get_cpu_gdt_paddr(cpu),
-		     pg_fixmap_gdt_flags);
+	__set_fixmap(get_cpu_gdt_ro_index(cpu), get_cpu_gdt_paddr(cpu), prot);
 }
 
 /* Load the original GDT from the per-cpu structure */
diff --git a/arch/x86/xen/enlighten.c b/arch/x86/xen/enlighten.c
index 08faa61de5f7..4951fcf95143 100644
--- a/arch/x86/xen/enlighten.c
+++ b/arch/x86/xen/enlighten.c
@@ -1545,9 +1545,6 @@ asmlinkage __visible void __init xen_start_kernel(void)
 	 */
 	xen_initial_gdt = &per_cpu(gdt_page, 0);
 
-	/* GDT can only be remapped RO */
-	pg_fixmap_gdt_flags = PAGE_KERNEL_RO;
-
 	xen_smp_init();
 
 #ifdef CONFIG_ACPI_NUMA
-- 
2.9.3