Re: [PATCH] ezchip: nps_enet: check if napi has been completed

[Eric Dumazet]

On Thu, Mar 30, 2017 at 2:16 AM, Vlad Zakharov
<Vladislav.Zakharov@xxxxxxxxxxxx> wrote:

> I am not sure what is happening with other drivers, but in case of ezchip nps_enet driver after the following commit:
> 39e6c8208d7b6fb9d2047850fb3327db567b564b
>
> if we got into NAPI_STATE_MISSED state the following happened:
> in nps_enet_poll func we were calling napi_complete_done() (which reset MISSED state but left SCHED state) and after
> that without any checks were enabling interrupts.
>
> Then we obviously were getting into nps_enet_irq_hanlder() if irq was pending (it is very possbile state). If we look
> inside this function we will see that it disables interrupts only in case napi_sched_prep() returns true. In its turn
> napi_sched_prep() returns true only in case it changes state from non-SCHED to SCHED. But in our case as SCHED had been
> already set it set MISSED state and then returned false. So at that point we had already been trapped: after exiting irq
> hanlder we were getting into nps_enet_irq_hanlder() again and again as we couldn't rescind pending irq signal and
> disable corresponding irq.

Hi Vlad

Considering the use of  napi_schedule_prep() in
nps_enet_irq_handler(), it is strange that nps_enet_poll() uses :

if (nps_enet_is_tx_pending(priv)) {
     nps_enet_reg_set(priv, NPS_ENET_REG_BUF_INT_ENABLE, 0);
     napi_reschedule(napi); // note the return value is ignored...
}

So nps_enet_poll() was enabling interrupts, then disabling them, which
seems very unusual.

I need to check all drivers using napi_schedule_prep() and/or
napi_reschedule() and make sure they also test napi_comple_done()
return value...

I count 12 drivers using napi_reschedule() without checking its return value.
They either should check its return value, or use conventional napi_schedule()

Thanks !