Re: [PATCH V1 1/1] mtd: mtk-nor: set controller to 4B mode with large capacity flash
From: Cyrille Pitchen
Date: Thu Mar 30 2017 - 14:59:09 EST
Hi Guochun,
Le 30/03/2017 à 10:23, Guochun Mao a écrit :
> when nor's size larger than 16MByte, nor and controller should
> enter 4Byte mode simultaneously.
>
> Signed-off-by: Guochun Mao <guochun.mao@xxxxxxxxxxxx>
> ---
> drivers/mtd/spi-nor/mtk-quadspi.c | 7 +++++++
> 1 file changed, 7 insertions(+)
>
> diff --git a/drivers/mtd/spi-nor/mtk-quadspi.c b/drivers/mtd/spi-nor/mtk-quadspi.c
> index e661877..05cd8a8 100644
> --- a/drivers/mtd/spi-nor/mtk-quadspi.c
> +++ b/drivers/mtd/spi-nor/mtk-quadspi.c
> @@ -369,6 +369,13 @@ static int mt8173_nor_write_reg(struct spi_nor *nor, u8 opcode, u8 *buf,
> /* We only handle 1 byte */
> ret = mt8173_nor_wr_sr(mt8173_nor, *buf);
> break;
> + case SPINOR_OP_EN4B:
> + /* Set nor controller to 4-byte address mode,
> + * and simultaneously set nor flash.
> + * This case should cooperate with default operation.
> + */
> + writeb(readb(mt8173_nor->base + MTK_NOR_DUAL_REG) | 0x10,
> + mt8173_nor->base + MTK_NOR_DUAL_REG);
This is not good: you should check in both mt8173_nor_read() and
mt8173_nor_write() whether nor->addr_width is either 3 or 4.
from include/linux/mtd/spi-nor.h:
* @addr_width: number of address bytes
Besides SPI commands using an op code from 4-byte address instruction
set always carry a 4-byte address. They can be used directly, without
sending the SPINOR_OP_EN4B before. So you cannot assume that addresses
will be 4-byte long only if your SPI controller driver has seen a
SPINOR_OP_EN4B command before. This assumption is wrong.
SPI controller driver should never check SPINOR_OP_* op codes like this.
Then, testing SPINOR_OP_RDSR from mt8173_nor_read_reg() or
SPINOR_OP_WRSR from mt8173_nor_write_reg() is not a good practice too:
op codes may change depending on the memory manufacturer. So testing op
code values like you do can work with some memories but maybe not all.
Finally, don't use 0x10, please define a macro instead.
Best regards,
Cyrille
> default:
> ret = mt8173_nor_do_tx_rx(mt8173_nor, opcode, buf, len, NULL, 0);
> if (ret)
>